Filter
Top Products
Left
Right
Record Output LightControlOutput
Left Right
Playback Subwoofer Output
On
Main
Main
Phantom
Power
PowerAmp
Assignment
Off
Monitor
Monitor
Preamp
Output
PowerAmp
Input
Main A
Monitor B
CD/Tape
46
44
45
40
38
39
47
48
43
42
41
PATCH BAY
CD / TAPE PLAYBACK
CD / TAPE RECORD OUTPUT
PHANTOM ON/OFF
SUB WOOFER OUTPUT
LIGHT CONTROLLER OUTPUT
PREAMP OUTPUT MAIN
PREAMP OUTPUT MONITOR
POWER AMP ASSIGN A
POWER AMP ASSIGN B
POWER AMP INPUT A
POWER AMP INPUT B
Jacks:
Jacks:
Switch:
Jack:
Jack:
:
:
Switch:
Switch:
:
:
These RCA jacks are used to play audio from CD,
Tape, Computer, DVD, Hard Disc, MP-3 or other
line level audio source. NOTE: Use the
PLAYBACK controls (#21 & #27) to adjust the
volume of the playback to the Main and Monitor
sections.
These RCA jacks deliver a MONO Line level
output to a recording device such as Tape
Recorder, Computer, Recordable DVD, Hard Disc,
MP-3 and more.
This switch turns on the phantom power to the
XLR input Jacks. This power supply is designed
to provide power for condenser microphones and
other devices.
This is a low pass sub woofer output. Crossover
point = 150 hz @ 12db/oct.
This is selective band-pass output designed to
deliver a Line level audio trigger signal to Lighting
Controller devices.
This ¼” Mono jack delivers a Line level output
from the MAIN Master section.
This ¼” Mono jack delivers a line level output
from the MONITOR Master section.
This switch determines which master section will
drive the A power-amp. Place the switch in the UP
position to have the MAIN mix signal to the A
power-amplifier. Place the switch in the down
position to have the MONITOR mix signal to the A
power-amplifier.
This switch determines which master section will
drive the B power-amp. Place the switch in the UP
position to have the MAIN mix signal to the B
power-amplifier. Place the switch in the down
position to have the MONITOR mix signal to the
B power-amplifier.
This ¼” Mono jack allows the A power-amplifiers
to be used with an external Line level input.
NOTE: When used, this jack will interrupt the
signal flow from the mixer section of the
KPM8420T.
This ¼” Mono jack allows the B power-amplifiers
to be used with an external Line level input.
NOTE: When used, this jack will interrupt the
signal flow from the mixer section of the
KPM8420T.
40V
9