Filter
Top Products
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
3
Step 15. Locate the TV IR cable and cut about five (5) inches from the
end (
see Figure 6
).
Step 16. Twist the connector end of the new IR cable to the ends of the
old IR cable and wrap securely with duct tape.
Refer to Figure 7
.
Note: Free all cables from one another and pull them individually, as
they are replaced.
Figure 6
Cut Wire Ties If Provided
Locate The TV IR Cable
Figure 7
Twist And Tape
Figure 8
Pull To Replace
Step 17. Pull the TV IR cable until the new cable is out. Unwrap the tape
and discard the old cable (
see Figure 8
).
Step 18. Locate the Remote Control receiver through the rectangular
slot and pull the cables out and cut the ends free, enough to wrap the end
of the new receiver. Then fish them through the rectangular hole while
pulling, to route through the frame cavity (
see Figure 9
. )
Step 19. Push the Remote Control receiver into the rectangular slot
(
refer to Figure 10
).
Figure 9
Pull Remote Receiver Cables Out