Filter
Top Products
CONNECTIONS & SETUP
33
Screen Setup for PC mode
Overview
This function works in the following mode:
Component1, Component2, RGB-PC, RGB-DTV, or HDMI/DVI.
Note: Some signal from some graphics boards may not function properly. If the results are unsatisfactory, adjust
your monitor’s position, size and phase manually.
Adjustment for screen Position, Clock, Phase
Press the
OOKK
button and then use
DD
or
EE
button to select
PPoossiittiioonn
,
CClloocckk
, or
PPhhaassee
.
Press the
GG
button and then use
DD EE FF GG
button to
make appropriate adjustments.
■
The
PPhhaassee
adjustment range is
--3322
~
++3322
.
The
PPhhaassee
only works in Component 1-2, RGB-PC and
RGB-DTV mode.
■
The
CClloocckk
adjustment range is
--5500
~
++5500
.
The
CClloocckk
only works in RGB-PC mode.
Press the
OOKK
button.
Initializing (Reset to original factory values)
Press the
OOKK
button and then use
DD
or
EE
button to select
RReesseett
.
Press the
GG
button and then use
FF
or
GG
button to select
YYeess
.
Press the
OOKK
button.
To initialize the adjusted values
This function allows you to return to the good picture repro-
duction programmed at the factory and cannot be change.
1
2
3
1
2
3
1 2 3
1 2 3
Position
Clcok
Phase
Reset
GG
Position
GG
Clcok
Phase
Reset
PPoossiittiioonn
This function is to adjust picture
to left/right and up/down as you
prefer.
CClloocckk
This function is to minimize any
vertical bars or stripes visible on
the screen background. And the
horizontal screen size will also
change.
PPhhaassee
This function allows you to
remove any horizontal noise and
clear or sharpen the image of char-
acters. In HDMI/DVI-PC mode,
PHASE is not available.
Initialize Settings
EE
DD
FF GG
Close
Close
9U0569A-1 Rev05-ING 06/8/23 3:28 PM Page 33