LG Electronics 60LP645H CRT Television User Manual


 
32
206-4232
Custom Master TV Setup (Cont.)
6. (PTC cloning only / Optional) Add Custom Channel and Aux
Input Labels: 2-5-4 + MENU Mode
Note: 2-5-4 + MENU Mode enables you to add/edit channel icons and
custom text labels in the PTC once the Master TV Setup has been
transferred as described in the previous step.
Access the Installer Menu, and press 2-5-4 + MENU SETTINGS on the
Installer Remote. Add/edit custom text labels and/or change icons for
the Channel-Time on-screen displays (see 2-5-4 + MENU procedural
information on page 33). Note that broadcast digital channels often
already have a broadcaster generated label. When you are finished,
press MENU SETTINGS to exit 2-5-4 + MENU Mode.
7. Verify the TV setup.
Make sure the TV features are set per your requirements. Also, if
cloning the PTC, verify that the channel lineup, channel icons, and
custom text labels are correct.
8. (Recommended) Lock the channel lineup.
Access the Installer Menu. Set item 028 CH. OVERIDE to 0 and press
OK to lock the channel lineup and restrict access to the TV setup
menus. Press OK again to save your changes and exit the Installer
Menu.*
The Master TV Setup is now ready to be copied to the predetermined
cloning tool—a USB memory device (.tlx or .tll le) or a clone programmer.
See cloning procedures in this document.
After verifying the TV Setup, set Installer
Menu item 028 CH. OVERIDE to 0.*
DIGITAL 19-3
WXYZ
MONO
STEREO SAP
Custom text label “WXYZ” created
in 2-5-4 + MENU Mode.
* This step prevents end users from
accessing channel settings (i.e., the
Channel Menu will be inaccessible/
grayed out).
028 CH. OVERIDE 000
(Continued from previous page)
5. (PTC cloning only) Transfer the TV setup menu settings to the commercial controller (PTC):
2-5-5 + MENU Mode
Note: This step is essential for successful cloning using a USB memory device / .tll
file or a clone programmer. Without this step, the PTC will not contain any of the TV
setup menu settings.
Note: The maximum number of channels (analog, digital, and Aux inputs) that can
be transferred to the PTC is 141. An attempt to transfer more than 141 channels of
any combination will result in a PTC Channel Map of exactly 141 channels; any extra
channels will not be available in the PTC Channel Map. For example, if you enabled
three Aux inputs in the Installer Menu and Auto Tuning found 141 channels, you must
edit the TV channel lineup to decrease the number of analog/digital channels to (at
most) 138 in order to accommodate the Aux inputs in the PTC Channel Map.
a) After the TV channel lineup has been edited and channel label icons added, tune to the
channel (source) for which you wish to transfer TV setup menu settings.
Note: If you intend to use a clone programmer for cloning purposes, this must be either
an analog channel or Aux input.
b) Access the Installer Menu, and press 2-5-5 + MENU SETTINGS on the Installer Remote to
initiate the transfer of the Master TV Setup to the PTC. The TV exits the Installer Menu and
then tunes through the channels in the channel lineup during the transfer. When the transfer
is complete, the TV tunes back to the channel that was tuned before the transfer began.