Filter
Top Products
16 Plasma TV
Installation
- This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital
signals from a digital set-top box or other digital external device, refer to the figure as shown below.
- This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).
How to connect
Use the TV’s COMPONENT (Y, P
B, PR) INPUT, RGB or HDMI/DVI jack
for video connections, depending on your set-top box connector. Then,
make the corresponding audio connections.
How to use
1. Turn on the digital set-top box. (Refer to the owner’s manual for the
digital set-top box.)
2. Use TV/VIDEO or COMP/RGB/HDMI on the remote control to select
Component 1, Component 2, RGB-DTV, or HDMI/DVI source.
HDSTB Setup
HDSTB Setup
AC INPUTAC INPUT
(R) AUDIO (L)
RGB-DTV OUTPUT
B
R
(R) AUDIO (L)
DIGITAL AUDIO
OPTICAL
(R) AUDIO (L)
DVI-DTV OUTPUT
DIGITAL AUDIO
OPTICAL
DVI
COMPONENT2
DIGITAL AUDIO(OPTICAL)
VIDEO INPUT
AUDIO INPUT
HDMI /
DVI(VIDEO)
CABLE
Cable
ANTENNA
HDMI-DTV OUTPUT
Digital Set-top Box
or
or
or
or
CableCARD
CableCARD
TM
TM
Setup
Setup
AC INPUTAC INPUT
CABLE
Cable
ANTENNA
How to use
Insert the CableCARD
TM
TM
received from Cable Service provider to
CableCARD
TM
TM
slot of TV back panel.
If Host or CableCARD
TM
TM
does not display on the screen, contact with Cable
service provider by phone.
Note :
• CableCARD
TM
TM
has the types of Motorola, Scientific Atlanta, SCM etc..
These 3 types of CableCARD
TM
TM
can be used for this PLASMA TV.
Signal
480i
480p
720p
1080i
Component 1/2
Yes
Yes
Yes
Yes
RGB-DTV,HDMI/DVI
No
Yes
Yes
Yes
Caution: When removing the CableCARD
TM
TM
, do not
fall it as this may cause impact to the
CableCARD
TM
TM
.