Filter
Top Products
28
21. Red Adjustment (Command2:v)
G To adjust red in colour temperature.
Transmission
Data Min : 0 ~ Max : 64
*
Refer to ‘Real data mapping 2’. See page 28.
[k][v][ ][Set ID][ ][Data][Cr]
Acknowledgement
[v][ ][Set ID][ ][OK][Data][x]
22. Green Adjustment (Command2:w)
G To adjust green in colour temperature.
Transmission
Data Min : 0 ~ Max : 64
*
Refer to ‘Real data mapping 2’. See page 28.
[k][w][ ][Set ID][ ][Data][Cr]
Acknowledgement
[w][ ][Set ID][ ][OK][Data][x]
23. Blue Adjustment (Command2:$)
G To adjust blue in colour temperature.
Transmission
Data Min : 0 ~ Max : 64
*
Refer to ‘Real data mapping 2’. See page 28.
[k][$][ ][Set ID][ ][Data][Cr]
Acknowledgement
[$][ ][Set ID][ ][OK][Data][x]
20. Colour Temperature (Command2:u)
G To adjust colour temperature.
You can also adjust CSM in the special menu.
Transmission
Data 0: Normal 1: Cool 2: Warm 3: User
[k][u][ ][Set ID][ ][Data][Cr]
Acknowledgement
[u][ ][Set ID][ ][OK][Data][x]
26. Orbiter (Command2:p)
G To control the orbiter function on/off. You can also
adjust orbiter in special menu.
Transmission
Data 0 : Orbiter off
1 : Orbiter on
[j][p][ ][Set ID][ ][Data][Cr]
Acknowledgement
[p][ ][Set ID][ ][OK][Data][x]
27. White Wash (Command2:q)
G To control the white wash function on/off. You can also
adjust White Wash in special menu.
Transmission
Data 0 : White Wash off
1 : White Wash on
[j][q][ ][Set ID][ ][Data][Cr]
Acknowledgement
[q][ ][Set ID][ ][OK][Data][x]
*
Real data mapping 1
0 : Step 0
A : Step 10 (Set ID 10)
F : Step 15 (Set ID 15)
10 : Step 16 (Set ID 16)
64 : Step 100
*
Real data mapping 2
0 : -10
5 : -9
A : -8
2D: -1
32: 0
37: +1
5F: +9
64: +10
24. PIP Input Select (Command2:y)
G To select input source for sub picture in PIP/Twin pic-
ture mode. You can also adjust input source for sub
picture using PIP INPUT button on remote control.
Transmission
Data 0: RGB1
1: COMPONENT
(or AV1)
2: VIDEO
(or AV2)
3: S-VIDEO
[k][y][ ][Set ID][ ][Data][Cr]
Acknowledgement
[y][ ][Set ID][ ][OK][Data][x]
25. Abnormal State (Command2:z)
G To recognize an abnormal state.
Transmission
Data 0: Normal (Power on and signal)
1: No signal (Power on)
2: Turn the monitor off by remote control
3: Turn the monitor off by sleep time function
4: Turn the monitor off by RS-232C function
5: 5V down
6: AC down
7: Fan Alam
[k][z][ ][Set ID][ ][FF][Cr]
Acknowledgement
* This function is “read only”.
[z][ ][Set ID][ ][OK][Data][x]