LG Electronics RH199HS DVD Recorder User Manual


 
7
Introduction
About the internal hard disk
drive
The internal hard disk drive (HDD) is a fragile piece of
equipment. Please use the recorder following the
guidelines below to protect against possible HDD
failure.
We recommend that you back up your important
recordings onto DVD discs in order to protect against
accidental loss.
Do not move the recorder while it is on.
Install and use the recorder on a stable, level
surface.
Do not block the rear vent/cooling fan.
Do not use the recorder in excessively hot or humid
places, or in places that may be subject to sudden
changes in temperature. Sudden changes in
temperature can cause condensation to form inside
the recorder. This can be a cause of HDD failure.
While the recorder is switched on, do not unplug
from the wall socket or switch the electricity off from
the breaker switch.
Do not move the recorder immediately after
switching it off. If you need to move the recorder,
please follow the steps below:
1. After the message POWER OFF is shown in the
display, wait at least two minutes.
2. Unplug from the wall socket.
3. Move the recorder.
If there’s a power failure while the recorder is on
there is a chance that some data on the HDD will
be lost.
The HDD is very delicate. If used improperly or in
an unsuitable environment, it is possible that the
HDD will fail after a few years of use. Signs of
problems include playback unexpectedly freezing
and noticeable block noise (mosaic) in the picture.
However, sometimes there will be no warning signs
of HDD failure.
If the HDD fails, no playback of recorded material
will be possible. In this case it will be necessary to
replace the HDD unit.
Card useable on this unit
(RH200MHS only)
Compact Flash Card (CF)
Micro Drive (MD), ST1 MD
Secure Digital Card (SD), Mini SD
Multi Media Card (MMC), MMC Plus, RS MMC,
MMC Mobile
xD-Picture Card (xD)
Memory Stick (MS), MS Duo, MS Pro, MS Pro Duo
Compatible with: FAT 12, FAT 16, or FAT 32
Only use the memory cards recommended above.
Regarding Write Protect
For cards that have a write protect switch, if the switch
is on it will not be possible to write, erase or format
the card.
Inserting/Removing the Memory Card
Inserting the card
Insert straight-in until it fits into place.
Removing the card
Slot 1: Withdraw the card carefully.
Slot 2: Press on the center of the card then withdraw
the card carefully.
Notes:
Keep the memory card out of reach of children. If
swallowed, seek medical advice immediately.
A memory card may not be used for this recorder
Do not extract the memory card in operating
(play, copy, move, etc.).
Using Memory Card
1. Insert a memory card.
2. Press HOME on the remote control.
3. Select [MUSIC] or [PHOTO] option.
4. Select [Memory Card 1] or [Memory Card 2] then
press ENTER.
Details for the options are on page 16.
Insert CF, MD, or
ST1 MD
Insert SD, Mini SD,
MMC, MMC Plus,
RS MMC, MMC Mobile,
xD, MS, MS Duo,
MS-Pro, or MS Pro Duo
card
Slot 1 Slot 2