Filter
Top Products
Hard Disk Installation
Page 12
1. Use a screwdriver to loosen the two screws on the rear
panel.
2. Grab the front panel and pull the chassis out of the
case.
3. Please ensure that the jumper on your hard drive is set
to the Master position.
Note: refer to your Hard Disk manual for the location of
the jumper!
4. Insert the IDE connector into the IDE socket on the
Hard Disk. Make sure that pin 1 on the cable connects
to pin1 on the hard disk. The location of pin 1 can be
identified by the red strip on the edge of the cable. The
IDE cable is ‘keyed’ to fit correctly into most hard
drives.
Screws
IDE Connector