Filter
Top Products
46
Table of user options
The following table shows the user options that are available, briefly describes them and shows the available settings for each. Default settings are shown in bold.
Option/Name Description Settings
Set display brightness Allows adjustment to brightness of front panel display. If default is not used then brightness is in the range 50%
6% to 100% (non-linear). 6% - 100%
Enable source memory On: Each source has its own volume, bass, treble, balance and fader settings. On
Off: All the sources use the same volume, bass, treble, balance and fader settings. Off
Enable IR sensor Enables/disables control of the unit from the handset. On
Off
Set IR modulation: IR out 1 Modulation frequency for infrared flasher 1. If default is not used then the frequency is in the range 36 kHz
1 to 576 kHz (non-linear). 1 to 576 kHz
Set IR modulation: IR out 2 Modulation frequency for infrared flasher 2. If default is not used then the frequency is in the range 56 kHz
10 to 2304 kHz (non-linear). 10 to 2304 kHz
Configure ACC socket Defines the use of the accessory socket (ACC). IR = infrared repeater IR
RCU = KNEKT remote control unit RCU
Configure Knekt mode Auto: Determines whether the unit is being used in a CONNECT or KNEKT system. Auto
Main: See KNEKT documentation. Main
Room: See KNEKT documentation. Room
User Options