Loewe 32 HD Flat Panel Television User Manual


 
8
120-240V
50/60Hz
SERVICE
IR-
Link
SYSTEM
ANT-2
PIP
UHF/VHF
AUDIO
IN 2
Y
IN1
AUDIO IN1
L R
AV 2 ( RGB )
Center Sub
L R
SOURROUND
DVI-INPUT
D-SUB
DVI-OUTPUT
CONTROL
RC5/
RC6
VGA
DISPLAY
DIGITAL
L R
AUDIO IN 3
L R
AUDIO OUT
C
R
/P
R
C
B
/P
B
IN2 OUT
AV 1
DVI-INPUT ✳✳
CONTROL
AC INPUT
220V-240Volt
D-SUB
TV
R
Connect LCD screen and antenna(e) to the Signal Box
TFT-LCD monitor Removing the connection cover
Do not just pull the cover (fig.) back
over the connections.
Reach into the opening in the cover
and pull it back slightly at the top until
it snaps open. Then pull the cover up
and out.
Connect both the system cables and
the power cable to the LCD screen as
shown in the figure.
Then replace the cover.
Switch on/off
Signal Box
The antenna sockets 1 and 2 are only available in the set version with ”Digital-TV upgrade kit 2 Sat/Twin-Sat CI”.
✳✳ The connection socket ”CONTROL” is only available for Spheros 32/37 HD and designed for a Motor Unit!
Note: For optimum picture resolution use the "Digital Visual Interface Input DVI" only connecting cables less than 2 meters long.
31963_021_RC3_GB 14.01.2005, 10:40 Uhr8