Filter
Top Products
!
34
In CH option select the related channel. In MODE there are CBR
(audio/video) and VBR (audio/video). AV is audio and video
synchronization, Video is the mode without audio (when there is no audio input
use this way to save HDD space).When in CBR, Framerate is Real time, Bitrate
is the related maximum data flux. Use direction key to select the different
bitrates. When in VBR, Framerate 1f/s-25f/s are selectable. Video Loss on
means that alarm will be on when the video is lost, and also trigger the relay
device.
Select the relevant Camera in CH (this recorder has 8-Ch alarm input).
TYPE has NO (normal open) NC (normal close) output modes. If the
Camera number in RECORD is selected, recording would be started for that
Camera automatically when there is alarm input. If the alarm output port is
chosen, it will trigger the corresponding relay when there is an alarm input.
DELAY means to extend the recording time after receiving alarm signal
clears.10, 20, 30 90SEC delays. When the outside alarm is cleared, the
system will extend the recording time automatically before closing alarm and
relay output. When Time 1 or Time 2 are on, if an alarm occurs within the time
of these settings, the recording will be triggered by alarm signals. The beginning
time should be earlier than the ending time. The setting in Time 2 should be
later than the setting in Time 1. ALMSVR IP is used to transmit the alarm signals
to the designated IP server.
Select the corresponding channel in CH, and choose the protocol
of the brand name of the corresponding pan-tilt decoder in
PROTOCOL. ADDR is the address of the corresponding PTZ Camera.
Image
CH 1
MODE CBR AV
FRAMERATE REAL
BITRATE 1024K
VIDEO LOSS OFF
COVERED OFF
VIDEO SET DEFAULT
TITLE 01 ON
CYCLE OFF
SAVE CANCEL
Alarm
Pan-tilt control