Filter
Top Products
32
15MF Series (15” LCD TV)
33
SETTING UP THE PC MODE (PERSONAL COMPUTER MONITOR)
No Resolution Mode V. Frequency (Hz) H. Frequency (kHz)
1 640 x 480 VGA VESA 60 59.940 31.469
2
800 x 600
SVGA VESA 56 56.250 35.156
3 SVGA VESA 60 60.317 37.897
4 1024 x 768 XGA VESA 60 60.004 48.363
20MF Series (20” LCD TV)
No Resolution Mode V. Frequency (Hz) H. Frequency (kHz)
1
640 x 480
VGA VESA 60 59.940 31.469
2
800 x 600
SVGA VESA 56 56.250 35.156
3 SVGA VESA 60 60.317 37.897
TROUBLE SHOOTING TIPS
No Power
• Check the TV power cord. Disconnect the power cord from the power outlet for 10 seconds, then
reinsert the plug into the outlet. Press POWER to turn on the TV again.
• Make sure the outlet is not on a wall switch.
• Make sure a fuse has not blown at the power outlet.
No Picture
• Check the antenna or Cable TV connections. Connect the antenna or Cable TV signal securely to the
TV’s 75Ω jack on the rear of the TV.
• Set TUNER MODE correctly. Details are on page 15.
• Activate AUTO PROGRAM to find all available channels. Details are on page 16.
• In case you hear only sound and don’t see any picture in S-Video or Video (CVBS) mode. Please check if
you have connected Video signal to S-Video or Video (CVBS) input. Only one of the two video inputs can
be connected to sound. This means that the same sound can be heared in S-Video and Video (CVBS)
mode.
No Sound
• Press the VOL+ and VOL- buttons to adjust the volume.
• Press the MUTE button on the remote control to cancel or restore the volume.
• If you have connected other equipment to the TV (such as a VCR or DVD Player), make sure the audio
cables are connected securely between the TV and the other equipment.
• Check the SOUND settings. Details are on page 19 or 21.
• In case you hear wrong sound in S-Video or Video (CVBS) mode. Please check if you have connected the
right sound signal to AV in (S-Video or Video input). Only one of the two video inputs can be connected
to sound, but both video signals can be connected. This means that only one of the two sound inputs can
be heared in S-Video and Video (CVBS) mode.
Remote Control does not work.
• Check the batteries. If necessary, replace them with two AAA heavy duty (zinc chloride) or alkaline
batteries.
• Clean the remote control as well as the remote control sensor on the front of the TV.
• Check the TV power cord. Disconnect the power cord from the power outlet for 10 seconds, then rein
sert the plug into the outlet. Press POWER to turn on the TV again.
• Make sure the outlet is not on a wall switch.
• Make sure a fuse has not blown at the power outlet.
• Always point the remote control toward the front of the TV (toward the remote sensor).
• Make sure that you use the supplied Magnavox Remote control, only the supplied Magnavox Remote
control can be used with this LCD-TV set.
TV displays wrong channel or no channels.
• Repeat channel selection.
• Add the channel number(s) into the TV’s memory. Use STORE. Details are on page 15.
• Make sure TUNER MODE is set correctly. Details are on page 15.
Then activate AUTO PROGRAM to set up all available channels. Details are on page 16.