Filter
Top Products
6
EN
I
NTRODUCTION
Attaching the Stand
You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
5
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.
Supplied Accessories5
1
Spread a thick and soft cloth over a
table.
Place the main unit face down onto it.
Make sure not to damage the screen.
2
Hang the hook under the bottom
of the main unit to the stand’s hole
(shown arrow
➀
), then slide down the
stand in the direction of the screen
(shown arrow
➁
).
Make sure not to put the AC power
cord between the stand and the
unit.
3
Drive Phillips pan screws in the 3
threaded holes at the bottom of the
stand with a screwdriver tightly.
To remove the stand from this unit
Unscrew the Phillips pan screws indicated by “
➂
”. Pull up the stand in the direction of the rear of the unit. Be careful not to drop the stand
when you remove it.
AAA
AAA
screw holes
front sidefront side
Tilt Stand
You can adjust the stand to change the angle of the unit (-2.5° to 10°).
5
-2.5°
10°
If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.
•
user manual
(1EMN24399)
quick start guide
(1EMN24400)
remote control
(NF801UD)
batteries
(AAA x 2)
Phillips pan screw for
attaching the stand x 3
(FPH34120)