Magnavox 22MD311B Flat Panel Television User Manual


 
21
English
INTRODUCTION
PREPARATION WATCHING TV
USING FUNCTIONS
OPERATING DVD
CONNECTING DEVICES
INFORMATION USEFUL TIPS
Channel
Before you begin:
Make sure the unit is connected to antenna or cable.
1 Use / to select the item you want to adjust, then press
OK.
Picture
Sound
Channel
Features
Language
DVD
Autoprogram
Channel List
Add Channels
Antenna
2 Adjust the following items.
Autoprogram
If you switch wires (e.g. between antenna and CATV) or if you
move the unit to a different area after the initial setting, or if
you restore the DTV channels you deleted, it is recommended
to use Autoprogram to perform a new channel search.
1 Use / to select [Autoprogram], then press OK.
2 Use / to select an appropriate option, then press OK.
Picture
Sound
Channel
Features
Language
DVD
Autoprogram will rescan all channels.
Auto programming may take more than 20
minutes to complete.
Select your signal source.
Back
Antenna
Cable
Antenna
Cable
Or
ANT.IN
• When connected to VHF / UHF antenna, select [Antenna].
• When connected to CATV, select [Cable].
[Autoprogram] will begin.
Please wait while the system is scanning for channels.
Auto programming may take more than 20 minutes to complete.
75%
Digital channels
10 ch
Analog channels
6 ch
MENU
Exit
• When the scanning and memorizing are completed, the
lowest memorized channel will be displayed.
Note
After setting [Autoprogram], using CH + / on the remote control
skips unavailable programs automatically.
If you are not receiving a signal from your cable service, contact
the Cable provider.
If you press
or MENU during autoprogram, the setup of TV
channels will be canceled.
Even if [Autoprogram] is completed, the channel setting will be
lost if the AC power cord is unplugged before the unit goes into
standby mode by pressing
.
The PIN code will be required once you set a PIN code in the
[Child Lock].
p. 23
If you want to change your PIN code, follow the instruction of
[Change PIN].
p. 25
Channel List
The channels selected here can be skipped when selecting the
channels using CH + / .
Those channels can still be selected with the Number buttons.
1 Use / to select [Channel List], then press OK.
2 Use / to select the channel you want to remove, then
press OK.
Picture
Sound
Channel
Features
Language
DVD
Highlight channels for
Ch Up / Down key selection.
DTV 11.1
DTV 11.2
DTV 11.3
Ch Select
OK
Watch / Skip
BACK
Back
• The channel display for the removed channel darkens.
You will not be able to select the channel again using
CH + / .
• To reactivate a removed channel, use / and press
OK. The registered channels are highlighted.
• When you remove a main channel, its subchannels are
removed as well.
Note
The channel with the [DTV] indicated on the display is ATSC.
Otherwise the channel is NTSC.