9
ANTENNA CONNECTION
If your antenna has a round cable
(75 Ω) on the end, then you’re ready to
connect it to the LCD TV. If your
antenna has flat, twin-lead wire (300Ω),
you first need to attach the antenna wires
to the screws on a 300-75Ω adapter(not
supplied).
Connect the antenna (or adapter) to the
TV jack (marked 75 Ω) on the rear of the
LCD TV. If the end of the antenna wire is
threaded, screw it down finger tight.
Connect the cable TV signal to the TV
jack (marked 75 Ω) on the rear of the
LCD TV. Screw it down finger tight.
1
BASIC CABLE TV CONNECTION
2
1
A
combination antenna receives normal
broadcast channels (VHF 2–13 and UHF
14–69). Your connection is easy because there is
only one 75 Ω antenna jack on the back of your TV,
and that’s where the antenna goes.
Y
our Cable TV signal into your home may
be a single, 75 Ω cable. If so, this
connection is very simple. Follow the step
below to connect your Cable TV signal to
your new LCD TV.
Outdoor or Indoor Antenna
(Combination VHF/UHF)
Twin-lead wire
to 300-75Ω adpter
or
Antenna
with 75Ω
cable
1
2
CONNECTING THE POWER CORD
Wall outlet
Connect the power cord to the AC IN
connector of the LCD TV.
Connect the other plug of the power
cord to a wall outlet.
1
Complete other connections prior to
connecting the power cord.
2
Rear Jack panel of Television
The Cable TV singal
from Cable Company
75Ω coaxial cable
1
HELPFUL HINT
Select weak signal mode via the smart
picture settings in case your antenna
connection is showing a lot of noise or
strange patterns.
MAG-26_eng 0104.indd 9 1/6/2005 10:30:37