Filter
Top Products
Hooking Up the TV/VCR (cont’d) 7
AUDIO VIDEO
STOP
EJECT
REW PLAY F.FWDREC
OTR
CHANNEL
VOLUME
POWER
EARPHONE
OUT
IN
VIDEO
IN
OUT
3CH
4CH
AUDIO
ANT.
OUT
IN
VIDEO
IN
OUT
3CH
4CH
AUDIO
ANT.
VIDEOAUDIO
• Before connecting an antenna or cable signal to the ANT(enna) Jack, make sure the pin is not bent. If the pin is
bent, straighten it as illustrated, then connect the antenna or cable signal to the ANT(enna) Jack.
• A rod antenna (not supplied) is available from Philips Service Solutions Group. The part number is 4835 303
37006. To order, call 1-800-851-8885. (This antenna will fit the CC13C1MG only.)
• Audio and video cables are not supplied.
Helpful Hints
Crooked Pin
Straight Pin
Bent pin
Plug
Cable
Hooking Up Your TV/VCR to Another Video Source
(VCR or Camcorder)
You may need this connection if you want to copy tapes or view tapes that you are playing on the VCR or
camcorder. Select channel 00 (A/V IN) at the TV/VCR when viewing tapes that are playing on the VCR
or camcorder. Details are on page 31.
AUDIO/VIDEO In Jacks
on front of TV/VCR
AUDIO/VIDEO OUT
Jacks on VCR
Connect an Audio cable to the AUDIO
OUT Jack on the VCR and to the AUDIO In
Jack on the front of the TV/VCR.
Connect a Video cable to the VIDEO OUT Jack on the
VCR and to the VIDEO In Jack on the front of the TV/VCR.
2
When all other connections are complete, plug in the TV/VCR’s power cord.
3
Before you turn on the TV/VCR, go to page eight.
D.
CC13C1MG