Filter
Top Products
VCR PLUS+ PROGRAM
PLUS CODE : – – – – – – – –
TO END PRESS EXIT
38 Timer Recording With the VCR Plus+ Programming System
Follow the steps below to program a timer recording using the
PlusCode programming numbers in your TV guide. Before you
begin, make sure:
● The clock has been set. If not, CLOCK MUST BE SET appears.
● Channels are programmed.
● There is a tape in the TV/VCR (make sure the tape’s record tab
is intact and the tape is long enough to record the program).
● You have completed the steps on pages 36-37.
Complete each step within 60 seconds of completing the
previous step. If you don’t, you may return to step 1.
1
Press the VCR PLUS+ button on the remote control. The on-
screen display shown below will appear.
2
Press the Number buttons to enter the PlusCode pro-
gramming number of the program you wish to record (this
number is different for every program, and it can be four to eight
digits long). Finally, press the VCR PLUS+ button.
3
To record the program once, press the Number 1 button
to select ONCE. To record the same program every day
from Monday through Friday, press the Number 2 button
to select DAILY. To record the same program every
week on the same day (such as every Saturday), press the
Number 3 button to select WEEKLY.
• If the power fails, programmed timer
recordings will be lost.
• You cannot set a timer recording if
the TV/VCR is in Record Defeat
mode. To set the Record Defeat
mode to OFF, see page 40.
• If CODE ERROR flashes after you
enter the PlusCode programming
number and press the VCR PLUS+
button, the number you entered was
incorrect (for example, too short). If
this happens, enter the correct num-
ber.
• CLASH may flash on the screen after
you complete step 2. This means
that the timer recording you just pro-
grammed and another timer record-
ing overlap, and thus the current
timer recording will not be carried
out.
Helpful Hints
VCR PLUS+ PROGRAM
1 ONCE
2 DAILY (MON - FRI)
3 WEEKLY
TO SELECT PRESS NUMBER
TO END PRESS EXIT
REW
PLAY
POWER
SPEED
MUTE
SLEEP
ALT.CH
CHANNEL
VOLUME
REC/OTR
STATUS/EXIT
MEMORY
PAUSE/STILL
MENU
CLEAR
VCR PLUS+
SMART
SOUND
STOP
F.FWD
– +
o
o
p
p
o
p
1
2 3
4
5 6
7
8 9
0
+100
1
2
3
VCR PLUS+ PROGRAM
PLUS CODE : 60590 – – –
TO SET PRESS VCR +
TO CORRECT PRESS CLEAR
TO END PRESS EXIT