Filter
Top Products
OR
ANT.IN
IN
OUT
Y
our Cable TV signal may be
a single (75Ω) cable or a
Cable Box installation. In either
case, the connection to the TV
is very easy.
CABLE
TV
C
ABLE/CABLE BOX
If you do not have a
Cable Box, then you're ready
to connect your Cable TV sig-
nal to the TV. Go to step 2.
If you have a Cable Box:
Connect the Cable TV signal
to the IN jack on the Cable
Box.
If you do not have a
Cable Box, connect the Cable TV
signal directly to the ANT(enna) IN
jack on the TV.
If you have a Cable Box:
Use a coaxial cable (not supplied)
to connect the OUT jack of the
Cable Box to the ANT(enna) IN
jack on the TV.
Back of TV
Coaxial cable
Cable Box
To select
only the channels on
your Cable system,
see Auto Install
(page 4).
If you use a Cable
Box, set the TV to
the same channel as
the CH 3/4 switch
on the back of the
Cable Box. Select
channels at the
Cable Box.
SMART
HELP
Cable TV Company
Cable TV Signal (75Ω)
Note to the Cable TV System Installer: This reminder is provided to call
the Cable TV system installer’s attention to Article 820-40 of the National
Electrical Code, which provides guidelines for proper grounding - in particular,
specifying that the cable ground shall be connected to the grounding system of
the building, as close to the point of cable entry as possible.
H
OOKING UP
Y
OUR TV (ANTENNA/CABLE CONNECTIONS) (CONT’D)
OUT TO TV
IN FROM ANT.
ANT.IN
OR
Back of VCR
T
he basic Antenna/Cable to
VCR to TV connection is
shown here. If you have a Cable
Box, refer to the VCR owner’s
manual for details.
VCR
TO
TV
BASIC CONNECTION
Connect your
Antenna or Cable signal to
the IN FROM ANT(enna)
jack on the VCR.
Connect a coaxial
cable (not supplied) to
the OUT TO TV jack
on the VCR and to the
ANT(enna) IN jack on
the TV.
Coaxial cable
Outdoor
VHF/UHF
Antenna
300 to 75Ω
Adapter
Cable TV signal
Back of TV
Refer to the VCR
owner's manual for other
possible connections and for
operating details.
VCR
- 3 -