Magnavox MVR630MG VCR User Manual


 
Hookups With a Cable Box/Direct Broadcast System (cont’d) 9
75
ANT /
CABLE
With this connection:
You may watch one channel while recording another.
You may not record scrambled channels.
Recording One Channel/Watching Another
1
Put the Cable Box/DBS on the same channel as the
VCR’s CH3/CH4 switch. Set the TV to the Cable
Box/DBS output channel (03 or 04).
Then, with the VCR in VCR position (the VCR/TV light
will appear on the display panel), use the CH(annel)
o/p button to select the channel you want to
record at the VCR. Start the recording.
2
Press the VCR/TV button once to put the VCR in
TV position. (The VCR/TV light will disappear.)
3
Select the channel you want to watch at the Cable
Box/DBS.
TVs ANTENNA
IN Jack
Cable Box/DBS
VCR
• When you play a tape, make sure
the Cable Box/DBS is set to the
same channel as the CH3/CH4
switch on the VCR. Set the TV to
the Cable Box/DBS output channel
(03 or 04).
Helpful Hint
Connections
1
Connect a Cable signal to the VCRs ANT(enna) IN Jack.
2
Use the supplied black RF coaxial cable to connect the OUT
Jack on the VCR to the IN Jack on the Cable Box/DBS.
3
Use a second RF coaxial cable (not supplied) to connect the
OUT Jack on the Cable Box/DBS to the ANTENNA IN Jack
on the TV.
1
2
3
Cable
Signal
RF coaxial cable
RF coaxial cable
mvr630mg.QX33 2/11/02 12:05 PM Page 9