Filter
Top Products
7EN
INTRODUCTION
(*) The unit can also be turned on by pressing these buttons.
1. Disc tray
• Place a disc when opening the disc tray.
2. A OPEN/CLOSE button*
• Press to open or close the disc tray.
3. DISC IN indicator
• This indicator lights up in blue when a disc is in this
unit.
4. Infrared sensor window
• Receive signals from your remote control so that you
can control the unit from a distance.
5. C STOP button
• Press to stop playback.
6. B PLAY button*
• Press to start or resume playback.
7. PLAY indicator
• This indicator lights up in green when discs or SD
card play back.
8. STANDBY-ON indicator
• This indicator lights up in red when the power is in
the standby mode.
9. QSTANDBY-ON button
• Press to turn on the unit, or to turn the unit into the
standby mode. (To completely turn off the unit, you
must unplug the AC power cord.)
• Press and hold for 10 seconds to shut down the unit.
10. SD card slot
• Insert an SD Memory Card and play back the
contents in it.
1. AC power cord
• Connect to a standard AC outlet to supply power to
this unit.
• Unplug this cord from the AC outlet to completely
turn off the unit.
2. HDMI OUT jack
• Use to connect a TV with an HDMI compatible port
with an HDMI cable.
3. AUDIO OUT jacks
• Use to connect a TV, an AV receiver / amplifier or
other device with an RCA audio cable.
4. COMPONENT VIDEO OUT jacks
• Use to connect a TV with component video inputs
with an RCA component video cable.
5. DIGITAL OUT (COAXIAL) jack
• Use to connect an AV receiver / amplifier, Dolby
Digital / DTS decoder or other device with a digital
audio coaxial input jack with a digital audio RCA
cable.
6. VIDEO OUT jack
• Use to connect a TV, an AV receiver or other device
with an RCA video cable.
Front Panel
STOP PLAY
STANDBY-ON
OPEN/
CLOSE
DISC IN
SD card
1 3 4 5 6* 72*
10
98
Rear Panel
L
Y
P
R
/C
R
P
B
/C
B
R
COAXIAL
COMPONENT
VIDEO OUT
AUDIO
OUT
VIDEO
OUT
DIGITAL OUT
PCM/BITSTREAM
HDMIOUT
65
4
3
2
1
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
INTRODUCTION C
ONNECTIONS
P
LAYBACK
F
UNCTION
S
ETUP
O
THERS
E5P00UD_01UD_EN.book Page 7 Friday, September 11, 2009 10:03 AM