Filter
Top Products
CE
This equipment is in compliance with the requirements of the following
regulations: EN 55022 Class B (2006); EN 55024 (1998+A1:2001+
A2:2003), (IEC/EN 61000-4-2 [1995+A1:1998+A2:2001)/-3(2006]).
C-Tick
This equipment is in compliance with the requirements of the following
regulations: EN 55022 (2006) Class B, AS/NZS CISPR22 © IEC: 2005.
VCCI
This equipment is in compliance with the requirements of the following
regulations: CISPR22 © IEC: 2005.
DRIVER INSTALLATION
Installing the device driver enables your computer’s operating system
to recognize the Hi-Speed USB 2.0 SVGA Converter once it’s connected.
Check your operating system and refer to the appropriate installation
procedure below to begin installing the device driver. IMPORTANT:
• Unplug
the Hi-Speed USB 2.0 SVGA Converter from your PC or
notebook before executing any setup or un-install program.
• Make sure you connect the display device to the VGA (DB15)
connector of the
Hi-Speed USB 2.0 SVGA Converter
and switch it
on before plugging the converter into an available USB 2.0 port on
your PC or notebook.
WindoWs 2000/XP
1. Insert the enclosed driver CD into the CD-ROM drive. The setup
program should be launched automatically; if not, go to Start, then
Run, and then double-click “D:\Setup.exe” (where D: is the path of
your CD-ROM drive).
2.
When the InstallShield
Wizard welcome screen
displays, click “Next” to
continue.
3