Filter
Top Products
7
Introduction Introduction
ENGLISH
ENGLISH
Introduction Connections Playback Function Setup Others
The unit can also be turned on by pressing the buttons with circled numbers.
Part Names and Functions
Front Panel
910111287
6
53
1
2
4
1. STANDBY indicator
This indicator lights up in red in standby
mode and turns off when the power is on.
2. POWER ON/STANDBY button
Press to turn on the unit, or to turn the unit
to the standby mode. (In standby mode, this
unit still consumes small amount of power.
To completely shut down the unit, you must
unplug the AC cord.)
3. HDMI RESOLUTION button
Press to set the HDMI jack’s video signal
output mode.
4. Infrared sensor window
Receives signals from your remote control so
that you can control the unit from a distance.
5. Display
Refer to “Front Panel Display” on page 9.
6. SD card slot
Insert an SD Memory Card, and play back the
contents in it.
7. H / G (SKIP DOWN/UP) button
Press to skip down/up titles/chapters/tracks/
files.
8. A (OPEN/CLOSE) button
Press to open or close the disc tray.
9. Disc tray
Place a disc when opening the disc tray.
10. B (PLAY) button
Press to start or resume playback.
11. C (STOP) button
Press to stop playback.
12. F (STILL/PAUSE) button
Press to pause playback.
Rear Panel
2ch AUDIO OUT
LR
AC IN
FLASHER
OUT
IN
VIDEO OUT
COMPONENT VIDEO OUT
DIGITAL OUT
COAXIAL
HDMI OUT
NETWORK
2 3 41 5
87
6
1. AC IN Terminal
Use to connect the AC cord to supply the
power.
2. DIGITAL OUT (COAXIAL) jack
Use digital audio coaxial cable to connect to
an AV receiver, Dolby Digital decoder or
other device with a digital audio coaxial
input jack.
3. COMPONENT VIDEO OUT jacks
Use a component video cable to connect to
a display device with component input jacks.
4. VIDEO OUT jack
Use an RCA video cable to connect to a TV
monitor, AV receiver or other device.
5. FLASHER IN / OUT jacks
This Input terminal is equipped for
controlling this unit by the external Infrared
(IR) control device. Connect the IR control
signal from a Keypad, IR repeater, etc. The
Output terminal repeats the IR signal which
was fed into the IR Flasher Input terminal for
another device.
6. 2ch AUDIO OUT jacks
Use an RCA audio cable to connect these
jacks to the 2-channel audio input jacks of
your amplifier with 2- channel input
terminals.
7. NETWORK Terminal
Use to connect a telecommunications
equipment with LAN cable.
8. HDMI OUT jack
Use an HDMI cable to connect to a display
with an HDMI input jack.
Note
• Do not touch the inner pins of the jacks on
the rear panel. Electrostatic discharge may
cause permanent damage to the unit.
E5KB1UD_v2 _EN.book Page 7 Tuesday, June 30, 2009 11:18 AM