Filter
Top Products
ENGLISH
8
RC9001 User Guide
1 Connect the Control Panel (or the docking station) to the PC with the USB
cable.
2 Place the original remote 4 to 6 inches (10-15 cm) from the Control Panel in
line with its learning eye.
Check if both the batteries are sufficiently charged.
3 Press and hold the key of the original remote for more than 1 second.
Tip With the Control Panel connected to the PC, you can test newly added codes via
the editor. You press the Test IR button and the code will be sent to the A/V
equipment.
To assign codes to the buttons in the code pages:
1 In the Tools menu, select My Database Quick Access.
2 Select the code from the list, drag-and-drop the code to the button.
5 Configure the Extenders used in the RC9001 System.
Tip When you are not using an Extender in the configuration file, you need to disable the
Wireless Settings in the System Properties.
1 Select the number of Extenders in the System Properties on the tab Extenders and
define the type.
2 Select the way the Control Panel will work together with the Extenders in the
System Properties on the tab Wireless Settings (Stand-Alone or Network) and
insert the requested settings.
Note The WiFi time out can be set from 15 minutes to 24 hours, depending on the
preference of the customer to optimize battery saving and response time when a
button is pressed.
3 Match each Extender to the device(s) by selecting the Extender in the Device
Properties on the Settings tab.
Note When the Extenders are used in a network, you need to configure the extenders with
the Extender Configuration Tool. For more information, please refer to the User
Guides for the RX8001 and RX9001 Extenders.
6 Configure the Settings for the Control Panel.
Set time & date and define the activation method, time outs and screen brightness in the
System Properties of the configuration file on the Control Panel Settings tab.
Note On the Control Panel, you can still change a limited set of settings. To access the
Settings on the Control Panel, press and hold the Settings icon on the touch screen
for 3 seconds.