Filter
Top Products
2Connecting Up
11
English
FLASHER
IN
VIDEO OUT
Y
OUT
IN
AC IN
RS-232C
S1
VIDEO
EXT.
INT.
COMPONENT
REMOTE CONTROL
MIXED 2CH
CENTER
COAX.
R
L
L
R
SUB W.
SURR.
FRONT
AUDIO OUT
OPT.
Ver1.1
HDMI
DIGITAL
R
C
B
C
1
4
2
3
Home theater video con nec tions
This player outputs video in a number
of different ways. Choose the one most
suit able for your system using the guide
below.
S-Video or composite video?
S-Video should give a better picture, so if
you have an S-Video input, use it. S-Video
cables are available from any good audio/
visual dealer.
Connecting HDMI cables
With an HDMI cable, both uncompressed
video data and digital audio data (e.g.,
LPCM or bit stream data such as Dolby
Digital, DTS, MPEG data or DVD Audio
Multi channel) can be trans mit ted with just
a single connector.
By transmitting DVD image data directly as
digital data without it being fi rst converted
into analog format, it becomes possible to
provide the very fi nest in image quality (see
pages 6, 40, 41, 46).
Note
• The HDMI output of this unit can be con nect ed
to a DVI jack on a TV or other device using a
conversion adapter. In this case, it is necessary
to use a TV or display with an HDCP-com pat i ble
DVI input.
• There may be no image output if con nect ed to
a TV or display that is not com pat i ble with the
above format.
• Refer to the instruction manual of the TV or
display to be connected to this unit for detailed
information regarding the HDMI terminal.
• When connecting a progressive input TV with the
component output of the player, select ON in
the Progressive setting (see page 44).
If your TV has a component video input, we
rec om mend using it to connect directly to the
COM PO NENT VIDEO OUT of this player.
Use the standard 3-jack component video
output.
If a component input
is not available to you,
connect this player to
your TV or AV receiver
using either the VIDEO
or S1 jacks.
Plug into a standard
AC wall outlet.
If your TV and projector have
a HDMI terminal for Video and
Audio Input, we recommend
using it to connect directly to
the HDMI out of this player.
Important
• Before making or changing any rear panel
connections, make sure that all components are
switched off and unplugged from the wall outlet.
• While a connected component is turned on,
do not unplug the power cord of this DVD
player from the wall outlet. The speaker may be
dam aged.