Filter
Top Products
[19] PLAY
In VCR or DVD mode: This button works the same way as the one on your original
remote control.
IN TV mode: Coloured key (Yellow), fasttext control or special equipment functions.
[20] STOP
In VCR or DVD mode: This button works the same way as the one on your original
remote control.
IN TV mode: Coloured key (Green), fasttext control or special equipment functions.
[21] REC (record)
This key works the same way as the one on your original remote control for your VCR.
In order to avoid mistakes, you have to press this key twice to activate this feature.
[22] PAUSE
In VCR or DVD mode: This button works the same way as the one on your original
remote control.
IN TV mode: Coloured key (purple), fasttext control or special equipment functions.
7.3. Setting the remote control for your TV, VCR, DVD player and satellite
receiver
To make your remote control suitable for your own equipment, you have to program it once.
You can do this by entering a code, related to the brand and type of equipment you want to
control. You can program any device under any MODE button. For example, if you have two
VCRs, you can program VCR 1 under VCR and VCR 2 under DVD.
7.3.1 Manual code entry
Take your code book and search for the list matching the device you are looking for, e.g. TV
or VCR. Next, find the relevant brand (e.g. Sony). Now you will see one or more 3-digit codes.
If there is more than one code, it depends on your equipment which code is correct.
Generally, the codes are displayed in order of age of the device. Older devices first, newer
devices last. Sometimes you will have to try several codes before you find the right code for
your device.
1. Make sure your device is switched on (for example the TV).
2. Press and hold SETUP [7] until the LED indicator stays lit. Release SETUP .
3. Press and release the mode button [3] of the device you want to control (for example
TV).
4. Enter the 3-digit code from the code book by using the key pad [9]. The LED [2] will
extinguish after the last digit is entered. If you have entered a wrong code, the LED will
flash for 3 seconds and then extinguish. You have to repeat steps 2-4.
5. Point the remote at your TV and press the POWER button [1].
Your device should now turn off. Check other functions (for example for a VCR FF or
REW, etc.). If certain functions are not responding, the entered code is not the correct
one. In that case repeat the steps above with the next corresponding code of your brand.
6. Repeat this procedure from step 1 for the other devices you want to control (VCR, DVD,
SAT,...).
14 MARMITEK