Filter
Top Products
8 MARMITEK
device until it changes channel. (The remote control transmits one infrared
signal per second. Wait until the device reacts.) When the device reacts, press
-/-- (12) to confirm the code. If you accidentally miss the code, you can stop the
search by pressing Prog- (6) and go back to the correct code by repeatedly
pressing this button. Press -/-- (12) to confirm the code.
Note: If certain functions of your device do not work, try the next code for your brand.
The search function will begin after the last confirmed code. If that was 030, the search
function will begin at 031 and will continue until the last possible code.
4.3 Automatically search for all brands
When you are looking for an unknown code, you can automatically search through all the
codes (AutoSearch).
Note: Because you can assign every device (DVD, satellite) to the VCR, CBL, DVD, AUDIO,
SAT-buttons, you first have to enter a 3-digit code for the type of device that you want to
operate (see the code book). For example: If you want to program a satellite on the DVD
button, you first have to enter a RANDOM satellite code from the code book and follow
the following steps:
1. Turn the device you want to operate on.
2. Press SETUP (9) and keep this button pressed until one of the mode LEDs stays
lit. Release the SETUP button.
3. Press the Mode button (2) of the device you want to operate. The LED will
flash once.
4. Press Prog+ (6) once. After a few seconds the remote control will begin to
search for the code (quick search, 1 code per second) When the device reacts,
press Prog+ (6) to slow down the search (1 code per 3 seconds). You can go
back with Prog- (6) (or forward with Prog+ (6)) if you went too far. When the
appliance reacts, press -/-- (12) to confirm the code.
Note: If certain functions on your appliance do npt work, try the next code for your
brand. The search function will begin after the last confirmed code. If that was 030, the
search function will begin at 031, and will continue until the last possible code.
4.4 Manually searching for codes
Note: Because you can assign every device (DVD, satellite) to the VCR, CBL, DVD, AUDIO,
SAT-buttons, you first have to enter a 3-digit code for the type of device you want to
operate (see the code book). For example: If you want to program a satellite on the DVD
button, you first have to enter a RANDOM satellite code from the code book and follow
the following steps:
1. Turn the device you want to operate on.
2. Press SETUP (9) and keep this button pressed until one of the mode LEDs stays
lit. Release the SETUP button.
3. Press the Mode button (2) of the device you want to operate and then release
it.