Filter
Top Products
1
234
5
6
7
8
9
POWER
0
QUICK
VIEW CALL
SLEEP
MENU
RESET
CAPTION/TEXT
CH.1/2
SET ENTER
MUTING
VOL
CH
TV
WIDER HOLE
AND BLADE
WARNING:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
IMPORTANT SAFEGUARDS
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
d. If the unit does not operate normally by
following the operating instructions.
Adjust only those controls that are
covered by the operating in structions, as
an improper adjustment of other controls
may result in damage and will often
require extensive work by a qualified
technician to restore the unit to its normal
operation.
e. If the unit has been dropped or the
cabinet has been damaged.
f. When the unit exhibits a distinct change
in performance, this indicates a need for
service.
REPLACEMENT PARTS- When replace-
ment parts are required, be sure the service
technician uses replacement parts specified
by the manufacturer or those that have the
same characteristics as the original part.
Unauthorized substitutions may result in fire,
electric shock or other hazards.
SAFETY CHECK- Upon completion of any
service or repairs to this unit, ask the service
technician to perform safety checks to
determine that the unit is in proper operating
condition.
WALL OR CEILING MOUNTING- The
product should be mounted to a wall or
ceiling only as recommended by the
manufacturer.
HEAT- The product should be situated away
from heat sources such as radiators, heat
registers, stoves, or other products
(including amplifiers) that produce heat.
NOTE TO CATV SYSTEM INSTALLER
This reminder is provided to call the CATV
system installer's attention to Article 820-40
of the NEC that provides guidelines for proper
grounding and, in particular, specifies that
the cable ground shall be connected to the
grounding system of the building, as close to
the point of cable entry as practical.
POWER-CORD PROTECTION- Power-supply
cords should be routed so that they are not
likely to be walked on or pinched by items
placed upon or against them, paying particular
attention to cords at plugs, convenience
receptacles, and the point where they exit from
the appliance.
LIGHTNING- To protect your unit during a
lightning storm, or when it is left unattended
and unused for long periods of time, unplug it
from the wall outlet and disconnect the
antenna or cable system. This will prevent
damage to the unit due to lightning and power
line surges.
POWER LINES- An outside antenna system
should not be located in the vicinity of
overhead power lines, or other electric light or
power circuits, or where it can fall into such
power lines or circuits. When installing an
outside antenna system, extreme care should
be taken to keep from touching such power
lines or circuits as contact with them might be
fatal.
OVERLOADING- Do not overload wall outlets
and extension cords as this can result in a risk
of fire or electric shock.
OBJECT AND LIQUID ENTRY- Do not push
objects through any openings in this unit as
they may touch dangerous voltage points or
short out parts that could result in fire or
electric shock. Never spill or spray any type of
liquid into the unit.
OUTDOOR ANTENNA GROUNDING- If an
outside antenna or cable system is connected
to the unit, be sure the antenna or cable
system is grounded so as to provide some
protection against voltage surges and built-up
static charges. Section 810 of the National
Electrical Code, ANSI/NFPA 70, provides
information with respect to proper grounding of
the mast and supporting structure, grounding
of the lead-in wire to an antenna discharge
unit, size of grounding conductors, location of
antenna discharge unit, connection to
grounding electrodes, and requirements for the
grounding electrode.
SERVICING- Do not attempt to service this
unit yourself as opening or removing cover
may expose you to dangerous voltage or other
hazards. Refer all servicing to qualified service
personnel.
DAMAGE REQUIRING SERVICE- Unplug this
unit from the wall outlet and refer servicing to
qualified service personnel under the following
conditions:
a. When the power-supply cord or plug is
damaged.
b. If liquid has been spilled, or objects have
fallen into the unit.
c. If the unit has been exposed to rain or water.
12.
13.
14.
15.
16.
17.
18.
19.
The lightning flash with arrowhead symbol, within
an equilateral triangle is intended to alert the user
to the presence of uninsulated dangerous voltage
within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric
shock to persons.
An appliance and cart combination should be
moved with care. Quick stops, excessive
force, and uneven surfaces may cause the
appliance and cart combination to overturn.
VENTILATION- Slots and openings in the
cabinet and in the back or bottom are provided
for ventilation, to ensure reliable operation of
the unit and to protect it from overheating.
These openings must not be blocked or covered.
The openings should never be blocked by
placing the unit on a bed, sofa, rug, or other
similar surface. This unit should never be
placed near or over a radiator or heat source.
This unit should not be placed in a built-in
installation, such as a bookcase, or rack
unless proper ventilation is provided or the
manufacturer's instructions have been
adhered to.
POWER SOURCE- This unit should be
operated only from the type of power source
indicated on the rating plate. If you are not
sure of the type of power supply to your home,
consult your appliance dealer or local power
company. For units intended to operate from
battery power, or other sources, refer to the
operating instructions.
GROUNDING OR POLARIZATION- This unit
is equipped with a polarized alternating
current line plug (a plug having one blade
wider than the other). This plug will fit into the
power outlet only one way. This is a safety
feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If the
plug should still fail to fit, contact your
electrician to replace your obsolete outlet. Do
not defeat the safety purpose of the polarized
plug. If your unit is equipped with a 3-wire
grounding-type plug, a plug having a third
(grounding) pin, this plug will only fit into a
grounding-type power outlet. This too, is a
safety feature. If you are unable to insert the
plug into the outlet, contact your electrician to
replace your obsolete outlet. Do not defeat
the safety purpose of the grounding-type plug.
READ INSTRUCTIONS- All the safety and
operating instructions should be read before
the unit is operated.
RETAIN INSTRUCTIONS- The safety and
operating instructions should be retained for
future reference.
HEED WARNINGS-All warnings on the unit
and in the operating instructions should be
adhered to.
FOLLOW INSTRUCTIONS- All operating
instructions should be followed.
CLEANING- Unplug this unit from the wall
outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp
cloth for cleaning.
ATTACHMENTS- Do not use attachments not
recommended by the unit's manufacturer as
they may cause hazards.
WATER AND MOISTURE- Do not use this
unit near water. For example, near a bathtub,
washbowl, kitchen sink, or laundry tub, in a
wet basement, or near a swimming pool.
ACCESSORIES- Do not place this unit on an
unstable cart, stand, tripod, bracket, or table.
The unit may fall, causing serious injury, and
serious damage to the unit. Use only with a
cart, stand, tripod, bracket, or table recom-
mended by the manufacturer.
REMOTE CONTROL
Before using the remote control transmitter, first install the batteries.
2. Install two "AAA" (penlight size) batteries.
3. Replace the battery compartment cover.
Use two "AAA" size penlight batteries (not
supplied) for the remote control. The batteries
may last approximately one year depending on
how much the remote control is used. For best
performance, it is recommended that batteries
should be replaced on a yearly basis, or when
the remote operation becomes erratic. Do not
mix old and new batteries or different types.
BATTERY PRECAUTIONS
These precautions should be followed when
using batteries in this device:
1. Use only the size and type of batteries
specified.
2. Be sure to follow the correct polarity when
installing the batteries as indicated in the
battery compartment. Reversed batteries
may cause damage to the device.
3. Do not mix different types of batteries
together (e.g. Alkaline and Carbon-zinc) or
old batteries with fresh ones.
4. If the device is not to be used for a long
period of time, remove the batteries to
prevent damage or injury from possible
battery leakage.
5. Do not try to recharge batteries not intended
to be recharged; they can overheat and
rupture.
(Follow battery manufacturer's directions.)
1. Open the battery compartment cover.
HOW TO INSTALL BATTERIES
TO USE AC POWER SOURCE
Use the AC polarized line cord provided for operation on AC. Insert the AC cord plug into a
standard 120V 60Hz polarized AC outlet.
POWER SOURCE
NOTES:
1. Never connect the AC line cord plug to other than the
specified voltage (120V 60Hz). Use the attached
power cord only.
2. If the polarized AC cord does not fit into a non-
polarized AC outlet, do not attempt to file or cut the
blade. It is the user's responsibility to have an
electrician replace the obsolete outlet.
3. If you cause a static discharge when touching the unit,
and the unit fails to function, simply unplug the unit
from the AC outlet, wait an hour, and plug it back in.
The unit should return to normal operation.
Polarized AC Cord
(One blade is wider than
the other.)
The exclamation point within an equilateral triangle
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
appliance.
S3126A
PORTABLE CART WARNING
(symbol provided by RETAC)
1.
2.
3.
4.
5.
6.
7.
8.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
1.
2.
3.
4.
POWER Button - Press to turn the TV on.
Press again to turn the TV off.
Direct Channel Selection Buttons (0-9) -
Allows direct access to any channel.
MUTING Button - To turn off the sound,
press this button once. The TV will be
silenced and the symbol "MUTING" will
appear on the screen. The muting feature
can be released by pressing the MUTING
button again or one of the VOL ▲/▼ button.
VOL (VOLUME) ▲/▼ Buttons - Press the
▲ button to increase, or the ▼ button to
decrease the volume level.
1
2
3
4
5
6
7
14
13
12
11
10
9
8
GROUND
CLAMP
ELECTRIC
SERVICE
EQUIPMENT
POWER SERVICE
GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
ANTENNA
LEAD IN
WIRE
NEC-NATIONAL ELECTRICAL CODE
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING
CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
S2898A
EXAMPLE OF ANTENNA GROUNDING
AS PER NATIONAL ELECTRICAL CODE
SLEEP Button - To set the TV to turn off
after a preset amount of time, press the
SLEEP button on the remote control.
The clock will count down 10 minutes
each time the button is pressed in the
order of 120, 110, 100, ······ 20, 10, 0.
After the sleep time is programmed,
the display will disappear then reappear
momentarily every ten minutes to remind
you the sleep timer function is operating.
To confirm the sleep time setting, press
the SLEEP button once and the remaining
time will be momentarily displayed. To
cancel sleep time, press the SLEEP button
repeatedly until the display turns to 0.
MENU Button - Press to display the On-
Screen menu function.
SET +/– Buttons - Press to select the
desired setting during On-Screen operations.
RESET Button - Press to reset the On-
Screen picture adjustments to their
factory preset positions.
QUICK VIEW Button - This button allows
you to go back to the previous channel
selected by just pressing the QUICK VIEW
button. Press this button again to return to
the channel you were watching.
CALL Button - When you press this
button, the channel number tuned will
appear on the upper right corner of the
screen. Press the button again to remove
display from the screen.
CH (CHANNEL) ▲/▼ Buttons - Press the
▲ button to change to a higher numbered
channel set into memory. Press the ▼
button to change to a lower numbered
channel set into memory.
ENTER Button - Press to enter or select
information for On-Screen operations.
CH.1/2 Button - Switches between
Channel 1 and Channel 2 in the Closed
Caption mode.
TV/CAPTION/TEXT Button - Press this
button to switch between normal TV
and the two Closed Caption modes
(captions and 1/3 of full screen text).
Closed Captioning will display text on
screen for hearing impaired viewers.
20.
21.
22.
23.
24.
8A.
9.
10.
11.
3I0-0101A E 1/1/32, 09:503