Filter
Top Products
43
TROUBLESHOOTING GUIDE
Check the following before requesting service:
SYMPTOM
GENERAL
No power.
P
ower on, but unit not functioning
properly.
No picture.
No sound.
Playback picture rolls.
The playback picture is poor.
The Search feature is not working.
The picture is not fitting properly.
The remote control is not working.
The Preferences menu cannot be
accessed (it is dimmed) in the
Setup menu.
POSSIBLE SOLUTION
Plug in the AC cord to an AC outlet.
U
nplug the unit and wait about one to
two hours to allow the player to dry.
This unit cannot play discs, other than
those listed on page 17.
Press the POWER/STANDBY button,
then unplug the power cord. Wait one
minute and then plug the unit back in.
Clean disc and insert label side-up.
This is normal; try another function.
Connect the equipment according to
the instructions in this manual.
Select the appropriate video input
mode, usually VIDEO or AV.
Connect the video cables securely.
Turn the TV on.
Connect the equipment according to
the instructions in this manual.
Select the appropriate audio input
mode.
Connect the audio cables securely.
Turn the audio receiver on.
Set unit to NTSC.
Clean the disc.
This is normal on some discs.
Select the correct TV type (PS, LB, WIDE)
which matches the TV you are using.
Install fresh batteries.
Install batteries according to the diagram.
Aim the remote at the sensor.
Operate within 20 ft., or reduce the light
in the room.
Remove the obstacle.
Remove the disc from the disc tray, as
there cannot be a disc inserted when
setting the preferences.
POSSIBLE CAUSE
AC cord unplugged.
C
ondensation has formed.
Wrong type of disc inserted.
Unit needs to be reset.
The disc is dirty or inserted incorrectly.
Some features and functions are not
available on all discs.
The equipment is not connected properly.
The INPUT of the TV is not set to receive
the disc signal output.
The video cables are not securely
connected.
The connected TV power is off.
The equipment is not connected properly.
The equipment connected with the audio
cable is not set to receive the disc signal
input.
The audio cables are not securely
connected.
The connected receiver’s power is off.
Unit needs to be reset to NTSC.
The disc is dirty.
Some discs have sections that do not
allow searching.
Wrong menu option is selected in the
Setup menu.
The batteries are weak or dead.
The batteries are not installed properly.
The remote is not aimed at the sensor.
Distance is too far or there is too much
light in the room.
There is an obstacle in the path of the
beam.
There is a disc in the disc tray.