Filter
Top Products
20
4 Press the Direct Channel Selection buttons or CH M/
? button to select the channel to be recorded.
5 Press the REC/OTR button.
“ ● ” and the channel number will
appear on the screen and the
Rec/Otr indicator will light.
3 Press the ▲ or ▼ button to se-
lect the AUTO REPEAT option,
then press the B or A button to
select the ON position.
1 Press the MENU button.
2 Press the B or A button to select
the
option.
TIMER REC SET
AUTO REPEAT
////
MENU
ON
CH
TIMER REC SET
AUTO REPEAT
////
MENU
OFF
CH
When either the F.FWD or REW button is pressed in the
PLAYBACK mode, the speed search picture will appear.
When pressed twice, the search picture will increase
speed. Speed search time depends upon the speed
used (SP, LP or SLP) during recording. See chart below.
To visually search backward or forward, press the REW
or F.FWD button once or twice in the PLAYBACK mode.
Press the PLAY button to resume normal viewing speed.
SPEED SEARCH TIMES
NOTES: • The audio output is muted during Speed
Search and Still.
• A few noise bars will appear on the TV screen
during Speed Search and Still.
• To prevent damage to the tape, Still and Speed
Search mode is automatically changed to the
Playback mode after 5 minutes.
Press the PAUSE/STILL button in the PLAYBACK mode.
Press the PLAY button or PAUSE/STILL button to resume
normal playback.
Press the SKIP SEARCH button in the PLAY mode. The
VCR will search forward through approximately 30
seconds of the tape (e.g. unwanted commercial time) for
each press of the SKIP SEARCH button (maximum six
presses) and then resume normal playback.
NOTE: To cancel repeat mode, follow above steps 1 and
2, then press the B or A button to select the OFF
position. Press the MENU button to return to the
TV. The repeat function is canceled automatically
when the unit is switched off or the tape is ejected.
1 Load a cassette tape with the erase prevention tab
intact.
2 Press the SPEED button to
select the desired tape speed
SP or SLP. The counter and SP
or SLP will appear on the screen
about 4 seconds.
3 Set the TV/CABLE option to the appropriate position
(see page 15).
00
:
00
:
00 SP
NOTES: • If power is switched off during recording,
the TV set goes off and the VCR continues
to record. Press the STOP button to halt
the recording and turn off the VCR.
• The TV/VCR channel cannot be changed
during recording.
Press the PAUSE/STILL button to avoid recording
unwanted material. “
” will appear on the screen and
the Rec/Otr indicator will blink on and off. Press the
PAUSE/STILL button or the REC/OTR button to
continue the recording.
NOTES: • The PAUSE mode will be changed to STOP
mode after five minutes to prevent damage to
the tape.
• AUTO REWIND FEATURE
This TV/VCR will automatically rewind the video
cassette when the tape has ended (except
during OTR and Timer Record). It will also eject
the video cassette.
• If the erase prevention tab is removed, the tape
will eject when the REC/OTR button is pressed
for recording.
Press the STOP button to stop recording.
“ ■ ” will appear on the screen.
SPECIAL PLAYBACK
TO VISUALLY SEARCH FOR DESIRED
POINTS
PICTURE SEARCH SPEED
PRESS TWICE
TAPE SPEED
PRESS ONCE
SP (Standard Play)
LP (Long Play)
SLP (Super Long Play)
SKIP SEARCH
TO WATCH STILL PICTURE
TO WATCH A TAPE REPEATEDLY
RECORDING A TV PROGRAM
RECORDING AND VIEWING THE
SAME TV PROGRAM
TV - VHF/UHF channels
CABLE - CABLE TV channels
TO STOP RECORDING
TO STOP RECORDING TEMPORARILY
4 Press the MENU button. If you
press the PLAY button, the tape
will play over and over until the
repeat mode is canceled.
PRESS TWICE
PRESS ONCE
5 X
9 X
15 X
3 X
7 X
9 X
TAPE SPEED
VIDEO CASSETTE TAPE
T120
2 hours
6 hours
T160
2-2/3 hours
8 hours
SP
Standard Play
SLP
Super Long Play
5M10421A E P18-25 26/5/04, 10:4520