Filter
Top Products
65
3. The remote control
1.3 Entering the code for a
HiFi amplifier
After executing steps a) to d), you
have about 15 seconds to make
further entries. If you do not do so,
the remote control returns automa-
tically to the TV operating level.
a) Use the Select key to select the opera-
ting level HiFi. The coloured HiFi LED
lights.
b) Press the key, release it and then
press the key until the LED blinks
twice.
c) Press the l–ll key. The LED blinks once.
d) Enter the appropriate code (see the
code list) with the numeric keys.
If the code is accepted, the LED again
blinks twice. If you enter a non-exi-
stent code, the LED lights once for
about two seconds.
1.4 Search function
Proceed as described above for input of
the code for VCR, DVD, CD, tuner or
tape until you reach the step where the
code number is entered. Now enter the
code "001" to select the search function.
The LED blinks twice. Then press the
search key (the actual key depends on
the operating level; see the table on
pages 10 and 11) and hold it until the
device stops or switches off (an Off or
STOP command is transmitted automati-
cally every 1.5 seconds).
Now release the Search key and press
the Select key to save the code which
was found.
At the end of the search, when all exi-
sting codes have been interrogated, the
corresponding LED blinks five times.
☞
2. Reading out a programmed
code
After executing steps a) to e), you
have about 15 seconds to make
further entries. If you do not do so,
the remote control returns automa-
tically to the TV operating level.
a) In order to see which code is pro-
grammed for an operating level, first
proceed as described in 1.1 a) to b).
b) Use the numeric keys to enter
ᕌ ᕌ ᕄ
. The LED blinks twice to
acknowledge the input.
c) Press numeric key
ᕃ
to display the
first digit of the code. The LED now
blinks several times to show the value
(e.g. the LED blinks three times: the
digit 3 is programmed).
d) Press numeric key
ᕄ
to display the
second digit of the code. The LED now
blinks several times to show the value
(e.g. the LED does not blink: the digit
0 is programmed).
e) Press numeric key
ᕅ
to display the
third digit of the code. The LED now
blinks several times to show the value
(e.g. the LED blinks seven times: the
digit 7 is programmed).
In this example the programmed code is
thus
ᕅ ᕌ ᕉ
.
If you lose track during this operation,
simply start again at step 2c).
☞
605 47 0024.A1 42TL92 D-GB 02.11.2005 15:59 Uhr Seite 65