Metz 42TM92 Flat Panel Television User Manual


 
67
DVD
On / Standby
Return
Angle
Audio
Subtitle
Numeric keys: title selection
Cursor up/down
Cursor left/right
OK / Enter
TV volume +/-
TV mute
MENU
Display
Pause
STOP/Search
PLAY
EJECT
Skip +
Skip –
Repeat
Select operating level
Title
H i F i
C D ( I-II )
TUNER ( )
Ȅ
T A P E ( )
ON: Display time/track
ON&AV, ON:On/Standby
ON:Radio-text on/off
ON&AV, ON: On/Standby
I-II & ON: CD I-II & ON: CD
& ON: Tuner
Ȅ
& ON: Tape input & ON: Tape input
Num.keys: title select. Num.keys: progr.select.
Title +/– Programme +/–
Frequency +/–
AMP volume +/- AMP volume +/- AMP volume +/-
Pause
STOP/OPEN-CLOSE/Search
Num.key =Search
Search
PLAY
AUX input AUX input AUX input
Select operating level Select operating level Select operating level
3. The remote control
Search:
Proceed as described above for entering the codes for VCR, DVD, CD, tuner, tape as far as the step
where the code number is entered. Then enter "001" for the search function. The LED blinks 2x to
acknowledge the input. Then press and hold the search key (which depends on the operating level;
see the table) until the device stops or switches off (a STOP or OFF command is automatically trans-
mitted every 1.5 seconds).
Then release the search key and press the Select key to save the code which was found.
Reset:
Proceed as described above for entering the codes for VCR, DVD, CD, tuner, tape as far as the step
where the code number is entered. Then enter "000" for the reset function. The LED blinks 2x to
acknowledge the input. All codes are now reset to the factory default settings.
The reset is executed for all operating levels, regardless of the level from which it is initiated.
Key
On
0...9
̆ ̄
̇ ̈
OK
Vol.+/–
Mute
Menu
Text
k
Info
P+
red
green
white
yellow
blue
I-II
TV
P-
21
k
AV
22
k
Select
23
Ȅ
& ON: Tuner
Ȅ
605 47 0024.A1 42TL92 D-GB 02.11.2005 15:59 Uhr Seite 67