Filter
Top Products
Instructions for use
English
5
• If the device does not respond at all or not to all of the
key commands, follow the instructions under
‘Setting the remote control’, or for online setup go to:
www.philips.com/urc.
Setting the remote control
This is only necessary if your device does not respond to the SRU 3040.
If that is the case, the SRU 3040 does not recognize the brand and/or model
of your device and you need to program the remote control to do so.
The example below (TV) instructs you how to do this.You can repeat the
same steps for other devices (DVD player/recorder,VCR and set-top box)
which you want to operate using the SRU 3040.
You can set the remote control either manually or automatically. If the brand
of your device is listed in the brand code list in the Quick Start Guide, you
can also set the remote control by Easy brand scan. For this see the Quick
Start Guide.
Manually setting the remote control
Example of TV:
1 Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2 Look up the brand of your TV in the
code list at the back of this manual.
One or more four-figure codes are shown for
each brand. Note the first code.
Be careful! There are separate tables for TV, DVD,
VCR and set-top box.
On our website www.philips.com/urc you can directly select your device
typenumber to find the right code.
Make sure you use the codes from the correct table.
3 Select TV: keep the TV key pressed for
5 seconds until it blinks twice and then
remains lit.
4 Then enter the code noted in step 2, using
the digil keys.
– The TV key will now blink twice.
If the key blinks once for an extended period,
the code has not been entered properly or
the wrong code has been entered.
Start again from step 2.
5 Point the SRU 3040 at the TV and check that it responds as it should.
– If the TV responds to all of the key commands, the SRU 3040 is ready
for use. Do not forget to note your code.
• If the device does not respond at all, or not to all of the
key commands, start again from step 2 and try the next code
from the list.