Filter
Top Products
67
For assistance call 1(800) 332-2119
6
NetCommand IR Control of an A/ V
Receiver
Controlling an A/V Receiver
after NetCommand Setup
Switching Audio to and from the A/V
Receiver
Press
1.
AUDIO.
Press
2.
to show the TV Speakers option.
Press
3.
to select either On (sound through TV
speakers) or Off (sound through A/V receiver).
Controlling A/V Receiver Power
With Any Connection Type
Press
1.
AUDIO.
Press
2.
to show the TV Speakers option.
Press
3.
to select Off.
Point the remote control at the
4.
TV (not the A/V
receiver) and press
POWER
to power the A/V
receiver on or off.
With an HDMI Connection
Press
1.
INPUT
.
Highlight the A/V receiver icon.
2.
Press
3.
POWER
.
Controlling Other A/V Receiver Functions
With the A/V receiver powered on and selected, the •
TV’s remote control operates the volume and mute
functions.
If you have performed setup to control A/V receiver •
switching over HDMI, when you switch to a device
in the Input Selection menu, the A/V receiver will
automatically switch to the correct audio input for
the device.
Note: Connect the HDMI cable between the TV
and A/V receiver first before performing
NetCommand setup for the A/V receiver. If you
perform NetCommand setup and then later con-
nect the cable, the NetCommand setup will be
lost.
NetCommand IR home-theater control is avail-
able on 265 series TVs. See the description of
NetCommand on “About NetCommand IR Control,”
page 60.
Two levels of NetCommand A/V receiver control are
available through the Inputs > AVR menu.
Power and volume.• See the next page.
Automatic audio and video switching over •
HDMI. See “Setup to Control Automatic Audio and
Video Switching via HDMI,” page 70.
Note: To set up control of other device types, see
“Initial NetCommand Setup,” page 62.
Downloaded From TV-Manual.com Manuals