Filter
Top Products
15
Special Features Buttons, Manual Analog Recording
Special Features
(Figure 13, page 13)
For both NetCommand® compatible traditional IR devices
and IEEE compatible devices, these buttons on your
TV remote control may also operate the similar functions
for the device:
CHANNEL
VOLUME
MUTE
Numbers -
HOME (EXIT)
ENT(er) (SELECT)
ADJUST
INFO
The exact function will depend on the device being used.
See the Appendix for additional information.
Record Button
(Figure 13, page 13)
The Record button allows you to record on both
NetCommand traditional IR devices and IEEE
compatible recording devices.
Recording On A NetCommand®
Traditional VCR
Pressing the Record button will function the same way as
pressing the record button on the VCR’s remote control or
front panel.
To record directly from antenna or cable:
. Display the Device Selection menu. Highlight the
traditional VCR and press POWER to turn on the
VCR. If necessary, press GUIDE to select the input
the VCR is on, such as Antenna input (or line input).
. Press ENT(er) to switch the HDTV Receiver to the
VCR.
. Select the correct channel for recording on the VCR
and then press REC to start recording. You will
need to manually stop the recording at the end of the
program. OR...
. Press the DEVICE MENU button to display the
VCR’s menu to schedule a delayed recording directly
from antenna or cable.
To record from the HDTV Receiver’s Ant-A, Ant-B,
Ant-DTV or other devices, see NetCommand Controlled
Recordings.