Mitsubishi Electronics WS-73711 Projection Television User Manual


 
22
23
Connecting an External Digital TV (TV or HTV) Receiver, cont.
External DTV Receiver with RGB
Video Connections
(Figure 1)
1. Connect the outside antenna, cable, or
satellite to ANT, or SATELLITE IN on the DTV
receiver (see your DTV receiver owner’s guide
for instructions, and cable compatibility).
2. Connect the incoming terrestrial antenna,
or cable (not satellite) to ANT-A on the TV
back panel (a coaxial splitter, available at most
electronic supply stores, may be required to
complete this installation).
3. Connect RGB cables for the DTV receiver to
Input-DTV on the TV back panel.
Note: You may need to set the Input-DTV
assignment to RGB instead of Y/Pr/Pb. Refer to
the Edit NetCommand™ Setup for instructions
on changing this setting.
DTV Receiver / TV Back Panel
• G (green) to Y/G
• R (red) to Pr/R
B (blue) to Pb/B
Note: If the DTV receiver has outputs for H
and V sync, connect as listed below (DO NOT
connect if DTV receiver uses “Sync on Green”
H (horizontal sync) to H
V (vertical sync) to V
4. Connect the L (left) and R (right) audio
cables from the DTV receiver to Input-DTV
AUDIO on the TV back panel.
Figure 1. Connecting the DTV receiver with RGB video
• See Appendix B for RGB video
signal compatibility information.
• For digital audio connections, see
your DTV Receiver and A/V Receiver
Owner’s Guides.
IMPORTANT