Filter
Top Products
16
Connecting an Antenna to a Cable Box and VCR,
Connecting Audio/Video to the Cable Box or VCR
Figure 6. Connecting the VCR Audio/Video.
Note: The TV side panel and connections shown here are for reference only and may vary by model.
You may connect to the S-VIDEO or VIDEO
terminal but not to both
.
Cable Box
(Figure 5)
1.
Connect the incoming cable to ANT on the TV
side panel.
NOTE: For best performance, please see Composite
Video with Audio or S-Video with Audio,
below.
Figure 5. Connecting the VCR with cable box.
Composite Video with Audio or S-
Video with Audio (Recommended)
(Figure 6)
1.
Connect a video or an S-Video cable from VIDEO
OUT on the VCR back panel to VIDEO or
S-VIDEO, INPUT-1 or INPUT-2 on the TV side
panel.
2. Connect a set of audio cables from AUDIO OUT
on the VCR back panel to AUDIO INPUT-1 or
INPUT-2 on the TV side panel.
• The red cable connects to the R (right) channel
• The white cable connects to the L (left) channel
If your VCR is mono (non-stereo), connect only the
white (left) cable.
IN
OUT
Antenna
AUDIO OUT
AUDIO IN
VIDEO OUT
(Y/C)
MONITOR
1
L
R
L
R
1
2
VCR back panel
If your VCR has a video
channel or RF ON/OFF
switch,set to OFF.
Attach
only
one
cable
type
1
Attach only
one cable type
1
White
Red
White
Red
TV side panel - left
(Recommended if available)
1
2
2
AUDIOOUT
AUDIOIN
VIDEOOUT
(Y/C)
MONITOR
1
L
R
L
R
1
2
IN
OUT
Antenna
VCRbackpanel
IncomingCable
CableBoxRearTerminals
INOUT
3
2
TVsidepanel(sectiondetail)
3
2
1