Filter
Top Products
3 - 18 3 - 18
MELSEC-Q
3 SPECIFICATIONS
(3) Automatic return function
When a station disconnected from a network due to a data link error recovers
from the error, the station is automatically reconnected to the network and
restarts data link.
(a) When a remote I/O station restarts data link (the "D.LINK" LED is lit.)
The remote I/O station resets all of the modules mounted on the station.
If data link is resumed by connecting/disconnecting the link cable, the
modules are not reset.
(b) When parameter change or reset of a remote I/O station (including power
cycle) was performed
After parameters of a remote I/O station are changed, if parameter change
or reset is performed at the remote master station, or if the remote I/O
station is reset (power off and then on, or the reset switch turned on), the
modules will be reset when the remote I/O station returns to the system to
resume the data link. Consequently, even if the output setting under a CPU
error is set to HOLD (retention) in an output module, digital-analog
converter module, or temperature control module, output cannot be
retained when data link is resumed.
Down
Remote
master
station
(station
No. 0)
Network No. 1 Network No. 1Return
1) The remote I/O station No. 2 is disconnected
due to a data link error.
2) The station No. 2 recovers to the normal
status and returns to the system.
Return
Remote I/O
station
(station
No. 1)
Remote I/O
station
(station
No. 2)
Remote
master
station
(station
No. 0)
Remote I/O
station
(station
No. 1)
Remote I/O
station
(station
No. 2)
Remote I/O
station
(station
No. 5)
Remote I/O
station
(station
No. 4)
Remote I/O
station
(station
No. 3)
Remote I/O
station
(station
No. 5)
Remote I/O
station
(station
No. 4)
Remote I/O
station
(station
No. 3)
POINT
There is a limit to the number of faulty stations that can return to the system within
one link scan. For details, refer to Section 5.1.4, "Supplementary Settings."