Filter
Top Products
5 - 3 5 - 3
MELSEC-Q
5 PARAMETER SETTINGS
Table 5.1 Remote master station network parameter setting items
Network station type
Parameter setting item
Remote master station
Reference
section
Settings with the network module
—
Section 4.3
Station number (STATION No.)
Section 4.3.1
Mode (MODE)
Section 4.3.2
Settings with GX Developer
—
Setting the number of modules (network type)
Section 5.1.1
Network settings
—
Section 5.1.2
Starting I/O No.
Section 5.1.2 (1)
Network No.
Section 5.1.2 (2)
Total stations
Section 5.1.2 (3)
Group No.
Section 5.1.2 (4)
Mode
Section 5.1.2 (5)
Common parameters
—
Section 5.1.3
Send range of each station (LX/LY settings)
Section 5.1.3 (1)
Send range of each station (LB/LW settings)
Section 5.1.3 (2)
Specify reserved station
Section 5.1.3 (3)
Supplementary settings
—
Section 5.1.4
Constant link scan
Section 5.1.4
Maximum No. of returns to system stations in 1
scan.
Multiplex transmission designation
Block send data assurance per station
Block receive data assurance per station
END asynchronous settings
Transient settings
Refresh parameters 3 4
Section 5.1.5
Valid module during other station access
Section 5.1.6
Interrupt settings
Section 7.7
Redundant settings
Section 5.1.7
Routing parameters
5
: Always set : Default setting exists : Set as needed : Setting not required
3: Default values are not set for LX/LY. Set the refresh parameters.
4: Default values are preset for LB/LW.
The CPUs other than the Universal model QCPU may operate even if
refresh parameters have not been set.
For the operation and precautions, refer to Section 5.1.5 (3).
5: For details, refer to the Q Series MELSECNET/H Network System
Reference Manual (PLC to PLC Network).
REMARKS
Always write network parameters to the remote master station.