Mitsubishi Electronics WD-73736 Projection Television User Manual


 
MODELS: WD-60735 / WD-60C8 / WD-65735 / WD-65736 / WD-65835 / WD-65C8 / WD-73735 /
WD-73736 / WD-73835 / WD-73C8
Page 14
BALLAST ASSEMBLY REMOVAL
REMOVAL PROCEDURE
1) Remove screw (A) from the Ballast support
and screw (B) if the Engine is still mounted
in the cabinet.
2) Slide the Ballast Assembly out the rear of
the Engine assembly and unplug the Lamp
connector (C) at the Ballast.
3) Disconnect connectors CJ1 and CJ3.
4) Remove screw (D) to remove the PWB-
BALLAST from the Ballast Support.
Reverse the procedure to install a new
Ballast .
SCREEN REMOVAL & REPLACEMENT
Screen Assembly (Bezel) Removal
1) Remove all rear screws (B) except one in an upper corner (To support the
screen assembly while removing the front mounting screws).
60 Inch Models
WD-65835 & WD-73835 Only
Escutcheon Removal
Before Removing the Screen Assembly
(V39++ Models Only)
1) Remove 2 screws (A) at the lower rear corner on
the right side.
2) Remove the small escutcheoncover to access the
SB1 connector
3) Unplug the SB1 connector. This disconnects the
PWB-SBL-R & PWB-SBL-L.
Downloaded From TV-Manual.com Manuals