Mitsubishi Electronics WS - 65313 Projection Television User Manual


 
74
Troubleshooting
Problem Possible Solution
• The TV remote control does not work. • Check that the batteries are installed correctly.
• Check that the selected switch is set to “TV”.
• Be no further than  feet from the TV when using the remote control.
• The TV takes several seconds to respond to channel commands. • Press ENTER after a channel number to avoid delays.
• Use the three digit number, i.e  for channel .
• You cannot access a channel. • Use number keys instead of CHANNEL up/down.
• Be sure the channel you want to view is in memory.
• Check that the TV is turned to the correct input source for that channel,
by pressing the INPUT button.
• Make sure the V-Chip setting is Off (page ).
• On-screen displays appear each time you change a function. • This is part of normal TV operation.
• You cannot program the TV to turn on automatically. • The TV may be locked.
• The clock may not be set.
• There is no sound even when the volume is turned up. • Check to see if the MUTE button is on.
• The TV’s “Listen to:” setting may be set to SAP.
• Check that “TV Speakers” setting is On.
• You have forgotten your lock passcode. • See Appendix A, Bypassing the V-Chip Lock (page ).
• Connected devices do not work correctly when the TV is off. • Energy Mode has been set to Low. Change to Standard (page ).
• PIP does not display a picture. • Make sure the V-Chip setting is Off (page ).
• Not all inputs can be displayed as a PIP (page ).
• The sound does not match the screen picture. • The TV’s “Listen to:” setting may be set to SAP.
• If using stereo or A/V reveiver speakers, check input selection on the
stereo or A/V receiver.
• If using stereo or A/V receiver, check that AUDIO is from MONITOR
OUT on TV’s back panel.
• There is a large black or gray rectangle on the screen. • The TV closed captioning has been set to “text” mode, but there is no
text information being broadcast. Turn Off in the CAPTIONS menu
(page ).
• Picture is out of focus, or colors are not aligned. • Adjust Convergence (page ).
• Check the Sharpness settings (page ).
• You cannot see a picture when you play a VCR tape. • If you connected your VCR with A/V cables, use the INPUT button to
select the Input source (INPUT-, INPUT-, or INPUT-) that the VCR
is connected to.
• Check your VCRs owner’s guide for further troubleshooting.
• V-Chip Lock is not working. • Make sure that V-Chip is On (page ).
• If V-Chip Hours/Lock by Time is currently set to disable the V-Chip
lock, the V-Chip will not block programming.
• Cannot set adjustments to factory setting • Follow the steps below to reset system defaults to factory settings.
. Press the MENU button followed by number buttons ,,and  on
the remote control.
Result: The above steps activate the Reset System Defaults menu screen
. Press the ENTER button on the remote control.
Result : The settings reset to factory defaults.
. Press the HOME or MENU button on the remote control to return to
the HOME or MENU screeen.
IMPORTANT: This function is not recommended unless it is mandatory
to reset system defaults to factory settings. This operation CANNOT be
undone and all customs settings will be erased.