Filter
Top Products
PAGE 16 — GB114BW GLOBUG SOLO LIGHTING SYSTEM — OPERATION & PARTS MANUAL — REV. #5 (01/06/09)
5. Before raising the mast, make sure the T-Handle Bolt
Lock (Figure 10) is securely tightened. This will prevent
the balloon/lamp assembly from falling off. In addition
make sure that the lamp power cable (balloon) is
connected to the lamp power cable (ballast).
6. Push down the mast and unhook the Mast Release Latch
(Figure 10). Extend the mast to the desired height.
GLOBUG SOLO LIGHTING SYSTEM — PRE-SETUP
CAUTION - READ MANUAL
Please read this entire manual carefully
before attempting to operate the GloBug
Solo. Failure to read this manual could
cause damage to the GloBug Solo and
serious injury to the operator.
GloBug Solo Setup
1. Place the GloBug Solo on a
firm level surface
so that it
will not slide or turn over. Make sure there is enough
space around the GloBug Solo for the outriggers to be
deployed.
2. Lock the three caster wheels (two wheels have no locks)
by stepping on the red end (S) of the caster lever
(Figure 7).
3. Pull outriggers downward at the ends until they lock in
place in the ground (Figure 8).
Figure 8. Outriggers (Deployed Position)
4. Expose the balloon by pulling down on the velcro tabs
and unzipping the protective cover as shown in Figure
9. Next, fold the protective cover into itself and zip.
Figure 9. Exposing the Balloon.
Figure 7. Locking Caster Wheels
Figure 10. T-Handle Bolt Lock and Mast Release Latch
DANGER SPRING LOADED MAST
The mast is spring loaded and will automatically extend when
unhooked. NEVER extend the mast with balloon or lamp
removed. The possibility exists of the mast rapidly shooting
upward.