Filter
Top Products
11
GB
Example
With just pressing Macro for AMP as device, you wish to switch on your AV receiver, TV and DVD player; select the
Video 1 input on the receiver and activate Play on the DVD player.
1 Press the POWER ON/OFF (No. 2) and MUTE keys (No. 14) together for approximately 2 seconds until STATUS
LED (No.1) stays red.
2 Press the required AMP DEVICE key (No.3); the AMP key will light up.
3 Using the numeric key-pad (No. 10) engage Macro Setup Mode for AMP Device: Press 77772. The STATUS
LED will flash once. If the code is wrong, the STATUS LED will flash twice.
4 Record the Macro by selecting the functions:
• Press POWER ON/OFF (No.2) (command for switching on AV receiver).
• Press SHIFT (No. 9); the STATUS LED changes to green. Press the TUNER/TV device key (No.3). The STATUS
LED will change to red again. Press POWER ON/OFF (command for switching on TV).
• Press DVD Device key; press POWER ON/OFF (command for switching on DVD player).
• Press AMP Device key; press VIDEO 1 (inside No. 10) (command for switching AV receiver to Video 1
input).
• Press DVD Device key; press PLAY/ENTER (No. 16) (command for activating Play on DVD player.
5 Press the Macro key (No. 23) to store the Macro. The STATUS LED and DEVICE key will go out and the Macro
is programmed.
To play back a Macro, select the required device and press Macro. The macro is now executed, for each remote
command send in succession, the corresponding DEVICE key will light up briefly.
NOTE
Set-up mode is automatically cancelled if no key is pressed for 15 seconds.
RESET TO FACTORY DEFAULT SETTINGS
Sometimes it may be necessary to reset the HTR-1 to its factory default settings, for instance, if you change many
components in your system or do not recall how keys were programmed.
TO RESET THE NAD HTR-1
Press the POWER ON/OFF (No. 2) and SELECT keys (No. 6) together for approximately 5 seconds until STATUS LED
(no.1) flashes twice.
NOTE
When you reset the remote to factory default settings, you will LOOSE ALL SETTINGS AND LEARNED REMOTE
COMMANDS; ONCE ACTIVATED, RESET CAN NOT BE UNDONE!
HTR1 manual 120mm 20/4/01 8:17 pm Page 11