Filter
Top Products
ENGLISH
FRANÇAISDEUTSCHNEDERLANDSESPAÑOL
ITALIANO
PORTUGUÊS
SVENSKA
5
1 DIGITAL OUT COAX Jack
2 DIGITAL OUT OPTICAL (With Dust Protection Cap) Jack
3 MIXED AUDIO OUT (L & R) Jacks
4 S-VIDEO OUT Jack
5 VIDEO OUT Jack
6 COMPONENT VIDEO OUT Jacks
7 +12V TRIGGER IN Jack
8 AUTO TRIGGER ON-OFF Switch
9 EXT. IR IN Jack
10 Power cord
REAR PANEL (NORTH AMERICAN VERSION)
Identification of Controls
NOTE
Remove the dust protection cap from the connector and connect the optical digital cable (not supplied) firmly so that the configurations of both
the cable and the connector match. Keep the dust protection cap and always reattach the cap when not using the connector to protect against
dust.
NOTE
The 12V TRIGGER IN jack is a 3.5mm monotype miniature phone jack with the centre pin the 12V signal-sense. We recommend that you use a
good quality cable with shield when attaching the 3.5mm monotype plug so as to prevent false triggering of the amplifier due to electro-magnetic
interference from nearby electronic equipment. The 12V-IN TRIGGER allows you to have an external 12V signal to turn ON the NAD S570 from
standby. This 12V signal must be a continuous 12V signal in order to keep the S570 in the ON state. Once you remove the 12V signal the S570
will return to standby. Check the specifications of the trigger input terminal on the other components to ensure these are compatible with the
S570. All 12V-TRIGGER inputs and outputs on other NAD components with a 12V-TRIGGER feature are fully compatible with the NAD S570’s
12V-TRIGGER IN. Before making any connections to any 12V-TRIGGER IN make sure all components are disconnected from the AC mains. If in
doubt over the connections, installation and/or operation of the 12V-TRIGGER IN connection, consult your NAD dealer or sales representative.
Failure to observe the above may result in damage to the NAD S570 and/or any ancillary components attached to it.
NOTE
The EXT. IR IN jack is connected to the output of an IR (infrared) repeater (Xantech or similar), or the IR output of another component to allow
control of the S570 from a remote location. Ask your dealer or custom installer for further details
OPTICAL
DIGITAL OUT
COAXIAL
MIXED
AUDIO OUT
VIDEO OUT S VIDEO
R
AUTO
TRIGGER
+12V TRIGGER IN EXT. IR IN
ON OFF
AC IN
COMPONENT
VIDEO OUT
Y
Cb/
Pb
Cr/
Pr
1
2
3
4
5
88
8 9
7
10
6