Filter
Top Products
LANGUAGE SETUP MENU
DISPLAY MENU
Select a language for the SETUP menu and on-screen display.
DISC MENU/AUDIO/SUBTITLE
Select the language you prefer for the audio track (disc audio), subtitles
and the disc menu. Depending on the media, only those Disc Audio, Disc
Subtitle and Disc Menu languages recorded on the media are available.
When a language is chosen, it will become the default setting unless the
media overrides the settings.
Original: Refers to the original language in which the disc was
recorded.
Other: Select “Other” if the desired language is not on the list. Use [ ] to
highlight “Other”, press [ENTER] and then input the 4-digit language code using
the number keys of the remote control. If you enter the wrong language code,
complete entering the 4-digit numbers, press [ENTER] and then encode the
correct 4-digit numbers. See “LANGUAGE CODE LIST” under the main heading
“REFERENCE” for a list of applicable language codes.
O: If you choose for the disc subtitle not to come up, select “O”.
AUDIO SETUP MENU
Each DVD disc has a variety of audio output options. Set the T 587’s AUDIO
options according to the type of audio system you use.
HDMI/SPDIF (DIGITAL AUDIO OUTPUT)
Select the audio output format for HDMI OUT or DIGITAL AUDIO OUT port.
PCM Stereo: Select when connected to a two-channel digital stereo
amplier.
PCM Multi-Ch (HDMI only): Select when connected to a device with
multi-channel decoder. This is applicable to HDMI OUT only.
DTS Re-Encode: Select when connected to a device with DTS
decoder.
Primary Pass-Thru: Select when connected to a device with LPCM,
Dolby Digital, Dolby Digital Plus, Dolby TrueHD, DTS and DTS-HD
decoder.
SAMPLE FREQ. (FREQUENCY)
Set the sampling frequency of the audio signal.
48KHz: If your receiver or amplier is not capable of handling 96 kHz
and 192 kHz signals, select 48 kHz. When this choice is made, this unit
automatically converts any 96 kHz and 192 kHz signals to 48 kHz so your
system can decode them.
96KHz: If your receiver or amplier is not capable of handling 192 kHz
signals, select 96 kHz. When this choice is made, this unit automatically
converts any 192 kHz signal to 96 kHz so your system can decode them.
192KHz: If your receiver or amplier is capable of handling 192 kHz
signals, select 192 kHz. When this choice is made, a 192 kHz signal
passes through without any further processing.
Check the documentation of your amplier to verify its capabilities.
DRC (DYNAMIC RANGE CONTROL)
You can select the eective dynamic range (subjective range from soft to
loud) for playback of Dolby Digital or Dolby Digital Plus soundtracks. It
is useful when you watch your favorite action movie without disturbing
others at night.
On: The “On” setting is for late-night sessions or other times when you
wish to retain maximum dialog intelligibility while minimizing overall
volume levels.
O: To maintain full dynamic range, set to “O”.
NOTE
DRC setting can be changed only at STOP mode or when there is no disc
loaded.
OPERATION
USING THE T 587
13
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ