NEC 50MP1 Flat Panel Television User Manual


 
48
*1 Only when using a graphic accelerator board that is capable of displaying 852ן480.
*2 This signal is converted to a 1228 dots ן 768 lines signal.
*3 The picture is displayed in the original resolution.
*4 The aspect ratio is 5:4. This signal is converted to a 960 dotן768 line signal.
*5 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, set the
RGB mode prepared for the input signals listed in the table above.
*6 To connect the monitor to Macintosh computer, use the supplied monitor adapter (D-Sub 15-pin) to your computer's video
port. If your computer has a mini D-Sub 15-pin connector, you may have to use the supplied RGB cable.
*7 Other screen modes (ZOOM and STADIUM) are available as well.
NOTE:
While the input signals comply with the resolution listed in the table above, you may have to adjust the position and size
of the picture or the fine picture because of errors in synchronization of your computer.
When a 1280 dot
ן
1024 line signal or 1600 dot
ן
1200 line signal is input to the monitor, the picture will be
compressed.
This monitor has a resolution of 1365 dot
ן
768 line. It is recommended that the input signal should be XGA, wide
XGA, or equivalent.
With digital input some signals are not accepted.
The sync may be disturbed when a nonstandard signal other than the aforementioned is input.
If you are connecting a composite sync signal, use the HD terminal.
* IBM PC/AT and VGA are registered trademarks of IBM, Inc. of the United States.
* Apple Macintosh is a registered trademark of Apple Computer, Inc. of the United States.