Filter
Top Products
E – 49
[Page 5]
Remote Sensor:
This option determines which remote sensors on the projector are
enabled in wireless mode.
The options are: front, rear, right, or left. All checked boxes indicate
that they can accept the infrared signal from the supplied remote
control.
S-Video Mode Select:
This feature is used to select the S-Video signal detection mode.
This allows identifying of the S-Video signals with different aspect
ratio (Zoom signal 16:9, Wide Zoom signal 4:3).
S2 ................ Identifies Zoom or Wide Zoom signal.
OFF .............. Does not identify any S-video signal.
[Page 6]
Communication Speed:
This feature sets the baud rate of the PC CONTROL connector
(Mini D-Sub 9 Pin).
It supports data rates from 4800 to 38400 bps.
The default is 38400 bps. Select the appropriate baud rate for your
equipment to be connected.
Projector ID
Each projector needs its own unique addresses when used in se-
rial communication mode. You can choose one of 64 unique ad-
dress using the spin box. First select Enable. Keep pressing in-
creases the number.
To make your setting available, select OK.
Default Source Select:
You can set the projector to default to any one of its inputs each
time the projector is turned on.
Last.............. Sets the projector to default to the previous or last active
input each time the projector is turned on.
Auto ............. Searches for an active source in order of RGB1 → RGB2 →
Video 1 → Video 2 → S-Video → PC Card Viewer → DVI
Digital → DVI Analog → RGB1(Standalone) and displays the
first found source.
Searching order in SW1 Level: from Slot 1 to 10
Searching order in SW2 Level: from Master projector 01,
Slave projector 01 to Master projector 10, Slave projector 10
Select ........... Displays the selected source input every time the projector is
started up. Select an input from the pull-down menu.
Link Mode (not available for DVI digital)
This feature is used for multiple projector connection using RGB
Digital Input/Output connectors. The master projector is set to Master.
The other slave projectors are set to Slave. When not using Link mode,
set to Standalone. See page E-16 for setting up for double stacking in
link mode.
Switcher Control
This feature sets the projector in communication with the NEC ISS-
6020 Switchers.
Stand Alone ................Use the projector in stand alone operation.
SW 1 Level..................Use the projector with one Switcher. (not available
in Link mode)
SW 2 Level..................Use the projector with two or more Switchers. (not
available in Link mode)
When changing this setting, the confirmation message will appear. If
you want to restart your projector, select Yes; if not, select No.
NOTE: This setting becomes effective only after the projector is restarted.