Filter
Top Products
E – 27
Connecting to a Single Workstation
You can connect a workstation to your GT2150 projector. To do so:
1. Turn off the power to your projector and workstation.
2. Use a BNC x 5 cable to connect your workstation and the RGB 1 connectors on your projector.
3. Turn on the projector and a workstation.
L/MONO
L/MONO
RGB 2
RGB 1
VIDEO 1
VIDEO 2
S
-
VIDEO AUDIO OUT
R/Cr G/Y B/Cb
VH/HV
R
L/MONO R
L/MONO R L/MONO R
R
L/MONO R
OUTPUT
ANALOG
DVI DIGITAL
DVI DIGITAL
To RGBHV output To RGBHV output
Signal distribution
BNCן5 cable
To analog RGB output
To analog
RGB input
Workstation
To RGBHV input
Installation Instructions
1. Open and attach the ferrite clamp core
to a signal cable as close as possible to
the end that goes to the projector.
Information for Reducing Radiation of Electromagnetic Waves
To reduce unnecessary radiation of electromagnetic waves, use the supplied ferrite clamp core,
* Push the catch to open the ferrite clamp core.
2. Close the ferrite clamp core tightly.
Band
3. Fix the supplied band to the cable as a stopper.
* Pull the end of the band to tighten it. Cut off the surplus of the band.
NOTE: Be sure to use the ferrite clamp core at the end of the signal cable.
To RGB1 input of GT2150
To a connected equipment
NOTE: All cables mentioned above are sold separately.
Supplied ferrite clamp core