Filter
Top Products
1. What’s in the Box? and the Names of the Projector Parts
6
1-3-2. Rear of the projector
1
2
3
4
5
6
1. Air inlet
Air is taken in here to provide cooling of the projector.
2. Air outlet
The heat of the lamp is vented here.
3. Power cord
Connect the power cord to an AC outlet.
4. Function ground
The function ground is used when you wish to establish a common ground potential between the projector and the image-
sending device or other equipment.
This is not a power supply ground terminal.
5. Main power switch
Connect the power cord to an AC outlet and set the main power switch to ON, then your projector will enter a standby state.
6. Lamp cover
The lamp house is accommodated. Mount and remove the lamps from here. For lamp mounting and removal, consult with
your dealer.
NOTE
• Do not cover the air inlet and outlet during operation. Inadequate air intake may lead to a rise in inside
temperature, thus causing a fire or serious projector failure.
• Do not touch the air outlet when your projector is operating. Otherwise, the high temperature may cause
burns.