Filter
Top Products
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373
5
4. Enter the first five-digit code for the device and brand that you wish to program. The
source key LED blinks once as each digit is entered. If the code is valid, source key the
LED blinks twice.
NOTE: IF THE SOURCE KEY LED DOES NOT BLINK TWICE, REPEAT STEPS 2 TO 4 AND TRY
ENTERING THE CODE AGAIN.
5. Aim the remote at the device and press POWER OFF. The device should turn Off. If it
does not, repeat steps 3–5, trying each code for your brand until you find one that
works. If you cannot find a code that works, see “SEARCHING FOR YOUR CODE”.
6. Repeat steps 1 to 5 for the other devices you want to control.
SEARCHING FOR YOUR CODE
If your device does not respond to the remote after trying all codes listed for your brand, or if your
brand is not listed, try searching for your code:
1. Turn the device you wish to control on.
2. Press a source key once.
3. Press and hold SETUP until the source key LED blinks twice, then release.
4. Enter 991, then the device group number (see table below). The source key LED blinks twice.
TABLE:
5. Aim the remote at the device and press POWER OFF. The remote sends IR codes from
its library to the selected device, starting with the most popular code first. If the
device responds, go to step 7.
6. If the device does not respond, press CH+ and the remote will test the next code for
that device type. Continue to press CH+ until the device turns Off.
NOTE: PRESS CH- TO TRY THE PREVIOUS CODE.
7. Now that you have found the correct code, press SETUP to save the code that worked
for your device. The source key LED will blink twice to indicate that the code has been
saved. To search for other device codes, repeat steps 1 to 5.
0 Cable (cable converters, video accessories, satellite receivers)
1 TV (TVs)
2 VCR (VCRs, DVD players )
3 Audio (audio amplifiers, audio amp/tuners, CD players)