Filter
Top Products
remote control) that you want the R-6L or R-8L Hand-Held Learning Remote Control
to learn. Press the source key for which you wish to learn keys.
2. Press and hold SETUP until the source key LED blinks twice, then release.
3. Enter 9 7 5. The source key LED blinks twice.
NOTE: IF THE SOURCE KEY LED DISPLAYS ONE LONG FLASH INSTEAD, YOUR BATTERIES ARE LOW, OR THE
HAND-HELD LEARNING REMOTE CONTROL HAS NO FREE MEMORY SPACE AVAILABLE. IN EITHER CASE, THE
REMOTE CANNOT LEARN A NEW KEY. REPLACE THE BATTERIES IF NECESSARY, OR IN THE CASE OF MEMORY
SPACE SHORTAGE DELETE CODES TO FREE SPACE.
4. Press the key on the Niles R-6L or R-8L Hand-Held Learning Remote Control you wish
to learn. The source key LED will blink rapidly for three seconds, indicating the remote
is ready to learn.
5. On the original remote, press and hold the key to be learned. Continue holding the
key on the original remote until the R-6L or R-8L Hand-Held Learning Remote Control
Source Key LED blinks twice.
NOTE: IF THE SOURCE KEY LED DISPLAYS ONE LONG BLINK, A LEARNING ERROR HAS OCCURRED. TRY
REPEATING THIS STEP AGAIN UNTIL A SUCCESSFUL CAPTURE IS OBTAINED. IF THE FUNCTION IS STILL NOT
CAPTURED, PRESS AND HOLD SETUP TO EXIT PROGRAMMING AND REVIEW THE “LEARNING PRECAUTIONS”
ABOVE. IF NEEDED, ALSO SEE “TROUBLESHOOTING”. AFTER REVIEW, START PROGRAMMING AGAIN AT STEP
1.
6. Repeat steps 4 through 5 for another key you would like to learn. Once you have
completed learning all keys, press and hold SETUP until the source key LED blinks
twice to save all data learned.
DELETING A SINGLE LEARNED KEY
This process returns the key to its original programming for the device you select. You can also
delete learned programming by teaching a different function to the key (see “Programming a
Learned Key”).
NOTE: IF MORE THAN 10 SECONDS PASS BETWEEN KEY PRESSES, THE REMOTE EXITS PROGRAMMING MODE.
1. Press the source key from which you wish to remove the learned key
2. Press and hold SETUP until the source key LED blinks twice, then release
3. Enter 9 7 6. The source key LED blinks twice
4. Press the key containing the learned function to be deleted twice. The source key LED
blinks twice and the remote exits from programming mode
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373
7